mac80211: mesh: Add support for HW RC implementation
Mesh HWMP module will be able to rely on the HW
RC algorithm if it exists, for path metric calculations.
This allows the metric calculation mechanism to calculate
a correct metric, based on PER and last TX rate both via
HW RC algorithm if it exists or via parameters collected
by the SW.
Signed-off-by: Maxim Altshul <maxim.altshul@ti.com>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
diff --git a/net/mac80211/mesh_hwmp.c b/net/mac80211/mesh_hwmp.c
index 8f9c3bd..fa7d37c 100644
--- a/net/mac80211/mesh_hwmp.c
+++ b/net/mac80211/mesh_hwmp.c
@@ -326,22 +326,33 @@
u32 tx_time, estimated_retx;
u64 result;
- if (sta->mesh->fail_avg >= 100)
- return MAX_METRIC;
+ /* Try to get rate based on HW/SW RC algorithm.
+ * Rate is returned in units of Kbps, correct this
+ * to comply with airtime calculation units
+ * Round up in case we get rate < 100Kbps
+ */
+ rate = DIV_ROUND_UP(sta_get_expected_throughput(sta), 100);
- sta_set_rate_info_tx(sta, &sta->tx_stats.last_rate, &rinfo);
- rate = cfg80211_calculate_bitrate(&rinfo);
- if (WARN_ON(!rate))
- return MAX_METRIC;
+ if (rate) {
+ err = 0;
+ } else {
+ if (sta->mesh->fail_avg >= 100)
+ return MAX_METRIC;
- err = (sta->mesh->fail_avg << ARITH_SHIFT) / 100;
+ sta_set_rate_info_tx(sta, &sta->tx_stats.last_rate, &rinfo);
+ rate = cfg80211_calculate_bitrate(&rinfo);
+ if (WARN_ON(!rate))
+ return MAX_METRIC;
+
+ err = (sta->mesh->fail_avg << ARITH_SHIFT) / 100;
+ }
/* bitrate is in units of 100 Kbps, while we need rate in units of
* 1Mbps. This will be corrected on tx_time computation.
*/
tx_time = (device_constant + 10 * test_frame_len / rate);
estimated_retx = ((1 << (2 * ARITH_SHIFT)) / (s_unit - err));
- result = (tx_time * estimated_retx) >> (2 * ARITH_SHIFT) ;
+ result = (tx_time * estimated_retx) >> (2 * ARITH_SHIFT);
return (u32)result;
}