[S390] cio: no path after machine check.
Devices enter no-path state after disabling a channel path
via the SE even though another path has been reenabled at the SE.
The devices are set into no-path state before triggering path
verification even though other paths may have become available.
To fix this trigger path verification before setting a device into
no-path state.
Signed-off-by: Peter Oberparleiter <peter.oberparleiter@de.ibm.com>
Signed-off-by: Martin Schwidefsky <schwidefsky@de.ibm.com>
diff --git a/drivers/s390/cio/chsc.c b/drivers/s390/cio/chsc.c
index 6405e9b..c28444a 100644
--- a/drivers/s390/cio/chsc.c
+++ b/drivers/s390/cio/chsc.c
@@ -238,8 +238,6 @@
/* Check for single path devices. */
if (sch->schib.pmcw.pim == 0x80)
goto out_unreg;
- if (sch->vpm == mask)
- goto out_unreg;
if ((sch->schib.scsw.actl & SCSW_ACTL_DEVACT) &&
(sch->schib.scsw.actl & SCSW_ACTL_SCHACT) &&
@@ -258,6 +256,8 @@
/* trigger path verification. */
if (sch->driver && sch->driver->verify)
sch->driver->verify(&sch->dev);
+ else if (sch->vpm == mask)
+ goto out_unreg;
out_unlock:
spin_unlock_irq(&sch->lock);
return 0;