cpufreq: speedstep: Use generic cpufreq routines
Most of the CPUFreq drivers do similar things in .exit() and .verify() routines
and .attr. So its better if we have generic routines for them which can be used
by cpufreq drivers then.
This patch uses these generic routines in the speedstep driver.
Cc: David S. Miller <davem@davemloft.net>
Signed-off-by: Viresh Kumar <viresh.kumar@linaro.org>
Signed-off-by: Rafael J. Wysocki <rafael.j.wysocki@intel.com>
diff --git a/drivers/cpufreq/speedstep-centrino.c b/drivers/cpufreq/speedstep-centrino.c
index f180561..c7c14ae 100644
--- a/drivers/cpufreq/speedstep-centrino.c
+++ b/drivers/cpufreq/speedstep-centrino.c
@@ -420,19 +420,6 @@
}
/**
- * centrino_verify - verifies a new CPUFreq policy
- * @policy: new policy
- *
- * Limit must be within this model's frequency range at least one
- * border included.
- */
-static int centrino_verify (struct cpufreq_policy *policy)
-{
- return cpufreq_frequency_table_verify(policy,
- per_cpu(centrino_model, policy->cpu)->op_points);
-}
-
-/**
* centrino_setpolicy - set a new CPUFreq policy
* @policy: new policy
* @target_freq: the target frequency
@@ -553,20 +540,15 @@
return retval;
}
-static struct freq_attr* centrino_attr[] = {
- &cpufreq_freq_attr_scaling_available_freqs,
- NULL,
-};
-
static struct cpufreq_driver centrino_driver = {
.name = "centrino", /* should be speedstep-centrino,
but there's a 16 char limit */
.init = centrino_cpu_init,
.exit = centrino_cpu_exit,
- .verify = centrino_verify,
+ .verify = cpufreq_generic_frequency_table_verify,
.target = centrino_target,
.get = get_cur_freq,
- .attr = centrino_attr,
+ .attr = cpufreq_generic_attr,
};
/*