spi: rspi: Round up division to avoid slave overclocking
The calculation of the bit rate divider used a standard C division, which
rounds down the quotient. This may lead to a higher bitrate than requested.
Round up to avoid this.
E.g. on Koelsch, the SPI flash (configured for 30 MHz) was driven at 48.75
MHz. After this patch it's driven at a safe 24.375 MHz.
Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
Signed-off-by: Mark Brown <broonie@linaro.org>
diff --git a/drivers/spi/spi-rspi.c b/drivers/spi/spi-rspi.c
index 1fb0ad2..5639f95 100644
--- a/drivers/spi/spi-rspi.c
+++ b/drivers/spi/spi-rspi.c
@@ -266,7 +266,8 @@
rspi_write8(rspi, rspi->sppcr, RSPI_SPPCR);
/* Sets transfer bit rate */
- spbr = clk_get_rate(rspi->clk) / (2 * rspi->max_speed_hz) - 1;
+ spbr = DIV_ROUND_UP(clk_get_rate(rspi->clk),
+ 2 * rspi->max_speed_hz) - 1;
rspi_write8(rspi, clamp(spbr, 0, 255), RSPI_SPBR);
/* Disable dummy transmission, set 16-bit word access, 1 frame */
@@ -302,7 +303,8 @@
rspi_write8(rspi, rspi->sppcr, RSPI_SPPCR);
/* Sets transfer bit rate */
- spbr = clk_get_rate(rspi->clk) / (2 * rspi->max_speed_hz) - 1;
+ spbr = DIV_ROUND_UP(clk_get_rate(rspi->clk),
+ 2 * rspi->max_speed_hz) - 1;
rspi_write8(rspi, clamp(spbr, 0, 255), RSPI_SPBR);
/* Disable dummy transmission, set byte access */
@@ -335,7 +337,7 @@
rspi_write8(rspi, rspi->sppcr, RSPI_SPPCR);
/* Sets transfer bit rate */
- spbr = clk_get_rate(rspi->clk) / (2 * rspi->max_speed_hz);
+ spbr = DIV_ROUND_UP(clk_get_rate(rspi->clk), 2 * rspi->max_speed_hz);
rspi_write8(rspi, clamp(spbr, 0, 255), RSPI_SPBR);
/* Disable dummy transmission, set byte access */