[ARM] Kirkwood: add NAND support to the DB88F6281 board
Signed-off-by: Nicolas Pitre <nico@marvell.com>
diff --git a/arch/arm/mach-kirkwood/db88f6281-bp-setup.c b/arch/arm/mach-kirkwood/db88f6281-bp-setup.c
index 5c3b40d..a513e10 100644
--- a/arch/arm/mach-kirkwood/db88f6281-bp-setup.c
+++ b/arch/arm/mach-kirkwood/db88f6281-bp-setup.c
@@ -13,8 +13,8 @@
#include <linux/platform_device.h>
#include <linux/pci.h>
#include <linux/irq.h>
-#include <linux/mtd/physmap.h>
#include <linux/mtd/nand.h>
+#include <linux/mtd/partitions.h>
#include <linux/timer.h>
#include <linux/ata_platform.h>
#include <linux/mv643xx_eth.h>
@@ -22,10 +22,53 @@
#include <asm/mach/arch.h>
#include <asm/mach/pci.h>
#include <mach/kirkwood.h>
+#include <plat/orion_nand.h>
#include <plat/mvsdio.h>
#include "common.h"
#include "mpp.h"
+static struct mtd_partition db88f6281_nand_parts[] = {
+ {
+ .name = "u-boot",
+ .offset = 0,
+ .size = SZ_1M
+ }, {
+ .name = "uImage",
+ .offset = MTDPART_OFS_NXTBLK,
+ .size = SZ_4M
+ }, {
+ .name = "root",
+ .offset = MTDPART_OFS_NXTBLK,
+ .size = MTDPART_SIZ_FULL
+ },
+};
+
+static struct resource db88f6281_nand_resource = {
+ .flags = IORESOURCE_MEM,
+ .start = KIRKWOOD_NAND_MEM_PHYS_BASE,
+ .end = KIRKWOOD_NAND_MEM_PHYS_BASE +
+ KIRKWOOD_NAND_MEM_SIZE - 1,
+};
+
+static struct orion_nand_data db88f6281_nand_data = {
+ .parts = db88f6281_nand_parts,
+ .nr_parts = ARRAY_SIZE(db88f6281_nand_parts),
+ .cle = 0,
+ .ale = 1,
+ .width = 8,
+ .chip_delay = 25,
+};
+
+static struct platform_device db88f6281_nand_flash = {
+ .name = "orion_nand",
+ .id = -1,
+ .dev = {
+ .platform_data = &db88f6281_nand_data,
+ },
+ .resource = &db88f6281_nand_resource,
+ .num_resources = 1,
+};
+
static struct mv643xx_eth_platform_data db88f6281_ge00_data = {
.phy_addr = MV643XX_ETH_PHY_ADDR(8),
};
@@ -59,6 +102,8 @@
kirkwood_sata_init(&db88f6281_sata_data);
kirkwood_uart0_init();
kirkwood_sdio_init(&db88f6281_mvsdio_data);
+
+ platform_device_register(&db88f6281_nand_flash);
}
static int __init db88f6281_pci_init(void)