drm/i915: sanitize rps irq enabling
Atm we first enable the RPS interrupts then we clear any pending ones.
By this we could lose an interrupt arriving after we unmasked it. This
may not be a problem as the caller should handle such a race, but logic
still calls for the opposite order. Also we can delay enabling the
interrupts until after all the RPS initialization is ready with the
following order:
1. disable left-over RPS (earlier via intel_uncore_sanitize)
2. clear any pending RPS interrupts
3. initialize RPS
4. enable RPS interrupts
This also allows us to do the 2. and 4. step the same way for all
platforms, so let's follow this order to simplifying things.
Also make sure any queued interrupts are also cleared.
v2:
- rebase on the GEN9 patches where we don't support RPS yet, so we
musn't enable RPS interrupts on it (Paulo)
v3:
- avoid enabling RPS interrupts on GEN>9 too (Paulo)
- clarify the RPS init sequence in the log message (Chris)
- add POSTING_READ to gen6_reset_rps_interrupts() (Paulo)
- WARN if any PM_IIR bits are set in gen6_enable_rps_interrupts()
(Paulo)
Signed-off-by: Imre Deak <imre.deak@intel.com>
Reviewed-by: Paulo Zanoni <paulo.r.zanoni@intel.com>
Signed-off-by: Daniel Vetter <daniel.vetter@ffwll.ch>
diff --git a/drivers/gpu/drm/i915/i915_irq.c b/drivers/gpu/drm/i915/i915_irq.c
index 21c579e..56b3053 100644
--- a/drivers/gpu/drm/i915/i915_irq.c
+++ b/drivers/gpu/drm/i915/i915_irq.c
@@ -255,14 +255,26 @@
snb_update_pm_irq(dev_priv, mask, 0);
}
+void gen6_reset_rps_interrupts(struct drm_device *dev)
+{
+ struct drm_i915_private *dev_priv = dev->dev_private;
+ uint32_t reg = gen6_pm_iir(dev_priv);
+
+ spin_lock_irq(&dev_priv->irq_lock);
+ I915_WRITE(reg, dev_priv->pm_rps_events);
+ I915_WRITE(reg, dev_priv->pm_rps_events);
+ POSTING_READ(reg);
+ spin_unlock_irq(&dev_priv->irq_lock);
+}
+
void gen6_enable_rps_interrupts(struct drm_device *dev)
{
struct drm_i915_private *dev_priv = dev->dev_private;
spin_lock_irq(&dev_priv->irq_lock);
WARN_ON(dev_priv->rps.pm_iir);
+ WARN_ON(I915_READ(gen6_pm_iir(dev_priv)) & dev_priv->pm_rps_events);
gen6_enable_pm_irq(dev_priv, dev_priv->pm_rps_events);
- I915_WRITE(gen6_pm_iir(dev_priv), dev_priv->pm_rps_events);
spin_unlock_irq(&dev_priv->irq_lock);
}