OHCI: work around for nVidia shutdown problem
This patch (as1417) fixes a problem affecting some (or all) nVidia
chipsets. When the computer is shut down, the OHCI controllers
continue to power the USB buses and evidently they drive a Reset
signal out all their ports. This prevents attached devices from going
to low power. Mouse LEDs stay on, for example, which is disconcerting
for users and a drain on laptop batteries.
The fix involves leaving each OHCI controller in the OPERATIONAL state
during system shutdown rather than putting it in the RESET state.
Although this nominally means the controller is running, in fact it's
not doing very much since all the schedules are all disabled. However
there is ongoing DMA to the Host Controller Communications Area, so
the patch also disables the bus-master capability of all PCI USB
controllers after the shutdown routine runs.
The fix is applied only to nVidia-based PCI OHCI controllers, so it
shouldn't cause problems on systems using other hardware. As an added
safety measure, in case the kernel encounters one of these running
controllers during boot, the patch changes quirk_usb_handoff_ohci()
(which runs early on during PCI discovery) to reset the controller
before anything bad can happen.
Reported-by: Pali Rohár <pali.rohar@gmail.com>
Signed-off-by: Alan Stern <stern@rowland.harvard.edu>
CC: David Brownell <david-b@pacbell.net>
Tested-by: Pali Rohár <pali.rohar@gmail.com>
CC: stable <stable@kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
diff --git a/drivers/usb/host/ohci-hcd.c b/drivers/usb/host/ohci-hcd.c
index c3b4ccc..8ef3c19 100644
--- a/drivers/usb/host/ohci-hcd.c
+++ b/drivers/usb/host/ohci-hcd.c
@@ -398,7 +398,14 @@
ohci = hcd_to_ohci (hcd);
ohci_writel (ohci, OHCI_INTR_MIE, &ohci->regs->intrdisable);
- ohci_usb_reset (ohci);
+ ohci->hc_control = ohci_readl(ohci, &ohci->regs->control);
+
+ /* If the SHUTDOWN quirk is set, don't put the controller in RESET */
+ ohci->hc_control &= (ohci->flags & OHCI_QUIRK_SHUTDOWN ?
+ OHCI_CTRL_RWC | OHCI_CTRL_HCFS :
+ OHCI_CTRL_RWC);
+ ohci_writel(ohci, ohci->hc_control, &ohci->regs->control);
+
/* flush the writes */
(void) ohci_readl (ohci, &ohci->regs->control);
}