drm/i915: Detect if MIPI panel based on VBT and initialize only if present
It seems by default the VBT has MIPI configuration block as well. The
Generic driver will assume always MIPI if MIPI configuration block is found.
This is causing probelm when actually there is eDP. Fix this by looking
into general definition block which will have device configurations. From here
we can figure out what is the LFP type and initialize MIPI only if MIPI
is found.
v2: Addressed review comments by Damien
- Moved PORT definitions to intel_bios.h and renamed as DVO_PORT_MIPIA
- renamed is_mipi to has_mipi and moved definition as suggested
- Check has_mipi inside parse_mipi and intel_dsi_init insted of outside
v3: Make has_mipi as a bitfield as suggested
Signed-off-by: Shobhit Kumar <shobhit.kumar@intel.com>
Reviewed-by: Damien Lespiau <damien.lespiau@intel.com>
[danvet: fold in conditions to pack everything neatly below 80 chars.]
Signed-off-by: Daniel Vetter <daniel.vetter@ffwll.ch>
diff --git a/drivers/gpu/drm/i915/i915_drv.h b/drivers/gpu/drm/i915/i915_drv.h
index 8f68678..4063ee1 100644
--- a/drivers/gpu/drm/i915/i915_drv.h
+++ b/drivers/gpu/drm/i915/i915_drv.h
@@ -1222,6 +1222,7 @@
unsigned int lvds_use_ssc:1;
unsigned int display_clock_mode:1;
unsigned int fdi_rx_polarity_inverted:1;
+ unsigned int has_mipi:1;
int lvds_ssc_freq;
unsigned int bios_lvds_val; /* initial [PCH_]LVDS reg val in VBIOS */
@@ -1245,6 +1246,7 @@
/* MIPI DSI */
struct {
+ u16 port;
u16 panel_id;
struct mipi_config *config;
struct mipi_pps_data *pps;