qla3xxx: bugfix: Fixed jumbo frame handling for 3032 chip.
The scatter/gather lists were not being build correctly. When
large frames spanned several buffers the chip would panic.
Signed-off-by: Ron Mercer <ron.mercer@qlogic.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/net/qla3xxx.c b/drivers/net/qla3xxx.c
index bdf1a40..4e9b25f 100755
--- a/drivers/net/qla3xxx.c
+++ b/drivers/net/qla3xxx.c
@@ -2122,11 +2122,13 @@
if (ip) {
if (ip->protocol == IPPROTO_TCP) {
- mac_iocb_ptr->flags1 |= OB_3032MAC_IOCB_REQ_TC;
+ mac_iocb_ptr->flags1 |= OB_3032MAC_IOCB_REQ_TC |
+ OB_3032MAC_IOCB_REQ_IC;
mac_iocb_ptr->ip_hdr_off = offset;
mac_iocb_ptr->ip_hdr_len = ip->ihl;
} else if (ip->protocol == IPPROTO_UDP) {
- mac_iocb_ptr->flags1 |= OB_3032MAC_IOCB_REQ_UC;
+ mac_iocb_ptr->flags1 |= OB_3032MAC_IOCB_REQ_UC |
+ OB_3032MAC_IOCB_REQ_IC;
mac_iocb_ptr->ip_hdr_off = offset;
mac_iocb_ptr->ip_hdr_len = ip->ihl;
}
@@ -2134,51 +2136,29 @@
}
/*
- * The difference between 3022 and 3032 sends:
- * 3022 only supports a simple single segment transmission.
- * 3032 supports checksumming and scatter/gather lists (fragments).
- * The 3032 supports sglists by using the 3 addr/len pairs (ALP)
- * in the IOCB plus a chain of outbound address lists (OAL) that
- * each contain 5 ALPs. The last ALP of the IOCB (3rd) or OAL (5th)
- * will used to point to an OAL when more ALP entries are required.
- * The IOCB is always the top of the chain followed by one or more
- * OALs (when necessary).
+ * Map the buffers for this transmit. This will return
+ * NETDEV_TX_BUSY or NETDEV_TX_OK based on success.
*/
-static int ql3xxx_send(struct sk_buff *skb, struct net_device *ndev)
+static int ql_send_map(struct ql3_adapter *qdev,
+ struct ob_mac_iocb_req *mac_iocb_ptr,
+ struct ql_tx_buf_cb *tx_cb,
+ struct sk_buff *skb)
{
- struct ql3_adapter *qdev = (struct ql3_adapter *)netdev_priv(ndev);
- struct ql3xxx_port_registers __iomem *port_regs = qdev->mem_map_registers;
- struct ql_tx_buf_cb *tx_cb;
- u32 tot_len = skb->len;
struct oal *oal;
struct oal_entry *oal_entry;
- int len;
- struct ob_mac_iocb_req *mac_iocb_ptr;
+ int len = skb_headlen(skb);
u64 map;
int seg_cnt, seg = 0;
int frag_cnt = (int)skb_shinfo(skb)->nr_frags;
- if (unlikely(atomic_read(&qdev->tx_count) < 2)) {
- if (!netif_queue_stopped(ndev))
- netif_stop_queue(ndev);
- return NETDEV_TX_BUSY;
- }
- tx_cb = &qdev->tx_buf[qdev->req_producer_index] ;
seg_cnt = tx_cb->seg_count = ql_get_seg_count((skb_shinfo(skb)->nr_frags));
if(seg_cnt == -1) {
printk(KERN_ERR PFX"%s: invalid segment count!\n",__func__);
- return NETDEV_TX_OK;
-
+ return NETDEV_TX_BUSY;
}
- mac_iocb_ptr = tx_cb->queue_entry;
- mac_iocb_ptr->opcode = qdev->mac_ob_opcode;
- mac_iocb_ptr->flags |= qdev->mb_bit_mask;
- mac_iocb_ptr->transaction_id = qdev->req_producer_index;
- mac_iocb_ptr->data_len = cpu_to_le16((u16) tot_len);
- tx_cb->skb = skb;
- if (skb->ip_summed == CHECKSUM_PARTIAL)
- ql_hw_csum_setup(skb, mac_iocb_ptr);
- len = skb_headlen(skb);
+ /*
+ * Map the skb buffer first.
+ */
map = pci_map_single(qdev->pdev, skb->data, len, PCI_DMA_TODEVICE);
oal_entry = (struct oal_entry *)&mac_iocb_ptr->buf_addr0_low;
oal_entry->dma_lo = cpu_to_le32(LS_64BITS(map));
@@ -2235,6 +2215,55 @@
oal_entry->len =
cpu_to_le32(le32_to_cpu(oal_entry->len) | OAL_LAST_ENTRY);
}
+ return NETDEV_TX_OK;
+}
+
+/*
+ * The difference between 3022 and 3032 sends:
+ * 3022 only supports a simple single segment transmission.
+ * 3032 supports checksumming and scatter/gather lists (fragments).
+ * The 3032 supports sglists by using the 3 addr/len pairs (ALP)
+ * in the IOCB plus a chain of outbound address lists (OAL) that
+ * each contain 5 ALPs. The last ALP of the IOCB (3rd) or OAL (5th)
+ * will used to point to an OAL when more ALP entries are required.
+ * The IOCB is always the top of the chain followed by one or more
+ * OALs (when necessary).
+ */
+static int ql3xxx_send(struct sk_buff *skb, struct net_device *ndev)
+{
+ struct ql3_adapter *qdev = (struct ql3_adapter *)netdev_priv(ndev);
+ struct ql3xxx_port_registers __iomem *port_regs = qdev->mem_map_registers;
+ struct ql_tx_buf_cb *tx_cb;
+ u32 tot_len = skb->len;
+ struct ob_mac_iocb_req *mac_iocb_ptr;
+
+ if (unlikely(atomic_read(&qdev->tx_count) < 2)) {
+ if (!netif_queue_stopped(ndev))
+ netif_stop_queue(ndev);
+ return NETDEV_TX_BUSY;
+ }
+
+ tx_cb = &qdev->tx_buf[qdev->req_producer_index] ;
+ if((tx_cb->seg_count = ql_get_seg_count((skb_shinfo(skb)->nr_frags))) == -1) {
+ printk(KERN_ERR PFX"%s: invalid segment count!\n",__func__);
+ return NETDEV_TX_OK;
+ }
+
+ mac_iocb_ptr = tx_cb->queue_entry;
+ mac_iocb_ptr->opcode = qdev->mac_ob_opcode;
+ mac_iocb_ptr->flags = OB_MAC_IOCB_REQ_X;
+ mac_iocb_ptr->flags |= qdev->mb_bit_mask;
+ mac_iocb_ptr->transaction_id = qdev->req_producer_index;
+ mac_iocb_ptr->data_len = cpu_to_le16((u16) tot_len);
+ tx_cb->skb = skb;
+ if (skb->ip_summed == CHECKSUM_PARTIAL)
+ ql_hw_csum_setup(skb, mac_iocb_ptr);
+
+ if(ql_send_map(qdev,mac_iocb_ptr,tx_cb,skb) != NETDEV_TX_OK) {
+ printk(KERN_ERR PFX"%s: Could not map the segments!\n",__func__);
+ return NETDEV_TX_BUSY;
+ }
+
wmb();
qdev->req_producer_index++;
if (qdev->req_producer_index == NUM_REQ_Q_ENTRIES)