powerpc/85xx: Add p2040 RDB board support
P2040RDB Specification:
-----------------------
2Gbyte unbuffered DDR3 SDRAM SO-DIMM(64bit bus)
128 Mbyte NOR flash single-chip memory
256 Kbit M24256 I2C EEPROM
16 Mbyte SPI memory
SD connector to interface with the SD memory card
dTSEC1: connected to the Vitesse SGMII PHY (VSC8221)
dTSEC2: connected to the Vitesse SGMII PHY (VSC8221)
dTSEC3: connected to the Vitesse SGMII PHY (VSC8221)
dTSEC4: connected to the Vitesse RGMII PHY (VSC8641)
dTSEC5: connected to the Vitesse RGMII PHY (VSC8641)
I2C1: Real time clock, Temperature sensor
I2C2: Vcore Regulator, 256Kbit I2C Bus EEPROM
SATA: Lanes C and Land D of Bank2 are connected to two SATA connectors
UART: supports two UARTs up to 115200 bps for console
USB 2.0: connected via a internal UTMI PHY to two TYPE-A interfaces
PCIe:
- Lanes E, F, G and H of Bank1 are connected to one x4 PCIe SLOT1
- Lanes C and Land D of Bank2 are connected to one x4 PCIe SLOT2
Signed-off-by: Mingkai Hu <Mingkai.hu@freescale.com>
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
diff --git a/arch/powerpc/platforms/85xx/p2040_rdb.c b/arch/powerpc/platforms/85xx/p2040_rdb.c
new file mode 100644
index 0000000..32b56ac
--- /dev/null
+++ b/arch/powerpc/platforms/85xx/p2040_rdb.c
@@ -0,0 +1,88 @@
+/*
+ * P2040 RDB Setup
+ *
+ * Copyright 2011 Freescale Semiconductor Inc.
+ *
+ * This program is free software; you can redistribute it and/or modify it
+ * under the terms of the GNU General Public License as published by the
+ * Free Software Foundation; either version 2 of the License, or (at your
+ * option) any later version.
+ */
+
+#include <linux/kernel.h>
+#include <linux/pci.h>
+#include <linux/kdev_t.h>
+#include <linux/delay.h>
+#include <linux/interrupt.h>
+#include <linux/phy.h>
+
+#include <asm/system.h>
+#include <asm/time.h>
+#include <asm/machdep.h>
+#include <asm/pci-bridge.h>
+#include <mm/mmu_decl.h>
+#include <asm/prom.h>
+#include <asm/udbg.h>
+#include <asm/mpic.h>
+
+#include <linux/of_platform.h>
+#include <sysdev/fsl_soc.h>
+#include <sysdev/fsl_pci.h>
+#include <asm/ehv_pic.h>
+
+#include "corenet_ds.h"
+
+/*
+ * Called very early, device-tree isn't unflattened
+ */
+static int __init p2040_rdb_probe(void)
+{
+ unsigned long root = of_get_flat_dt_root();
+#ifdef CONFIG_SMP
+ extern struct smp_ops_t smp_85xx_ops;
+#endif
+
+ if (of_flat_dt_is_compatible(root, "fsl,P2040RDB"))
+ return 1;
+
+ /* Check if we're running under the Freescale hypervisor */
+ if (of_flat_dt_is_compatible(root, "fsl,P2040RDB-hv")) {
+ ppc_md.init_IRQ = ehv_pic_init;
+ ppc_md.get_irq = ehv_pic_get_irq;
+ ppc_md.restart = fsl_hv_restart;
+ ppc_md.power_off = fsl_hv_halt;
+ ppc_md.halt = fsl_hv_halt;
+#ifdef CONFIG_SMP
+ /*
+ * Disable the timebase sync operations because we can't write
+ * to the timebase registers under the hypervisor.
+ */
+ smp_85xx_ops.give_timebase = NULL;
+ smp_85xx_ops.take_timebase = NULL;
+#endif
+ return 1;
+ }
+
+ return 0;
+}
+
+define_machine(p2040_rdb) {
+ .name = "P2040 RDB",
+ .probe = p2040_rdb_probe,
+ .setup_arch = corenet_ds_setup_arch,
+ .init_IRQ = corenet_ds_pic_init,
+#ifdef CONFIG_PCI
+ .pcibios_fixup_bus = fsl_pcibios_fixup_bus,
+#endif
+ .get_irq = mpic_get_coreint_irq,
+ .restart = fsl_rstcr_restart,
+ .calibrate_decr = generic_calibrate_decr,
+ .progress = udbg_progress,
+ .power_save = e500_idle,
+};
+
+machine_device_initcall(p2040_rdb, corenet_ds_publish_devices);
+
+#ifdef CONFIG_SWIOTLB
+machine_arch_initcall(p2040_rdb, swiotlb_setup_bus_notifier);
+#endif