at86rf230: remove unnecessary spinlock
This spinlock isn't necessary because if we are in TX_ON/TX_ARET_ON
state the transceiver can't be interrupted e.g. by receiving a frame
when a SHR was detected. In this time the transceiver doesn't leave
the TX_ON/TX_ARET_ON state until the tx complete irq change the state
into RX_AACK_ON again. This means a receiving interrupt in state
TX_ON/TX_ARET_ON can't happen and is_tx is protected by transceiver.
Signed-off-by: Alexander Aring <alex.aring@gmail.com>
Signed-off-by: Marcel Holtmann <marcel@holtmann.org>
diff --git a/drivers/net/ieee802154/at86rf230.c b/drivers/net/ieee802154/at86rf230.c
index cc5efa1..1278dd5 100644
--- a/drivers/net/ieee802154/at86rf230.c
+++ b/drivers/net/ieee802154/at86rf230.c
@@ -25,7 +25,6 @@
#include <linux/irq.h>
#include <linux/gpio.h>
#include <linux/delay.h>
-#include <linux/spinlock.h>
#include <linux/spi/spi.h>
#include <linux/spi/at86rf230.h>
#include <linux/regmap.h>
@@ -96,8 +95,6 @@
unsigned long cal_timeout;
s8 max_frame_retries;
bool is_tx;
- /* spinlock for is_tx protection */
- spinlock_t lock;
u8 tx_retry;
struct sk_buff *tx_skb;
struct at86rf230_state_change tx;
@@ -878,10 +875,8 @@
static void
at86rf230_irq_trx_end(struct at86rf230_local *lp)
{
- spin_lock(&lp->lock);
if (lp->is_tx) {
lp->is_tx = 0;
- spin_unlock(&lp->lock);
if (lp->tx_aret)
at86rf230_async_state_change(lp, &lp->irq,
@@ -894,7 +889,6 @@
at86rf230_tx_complete,
true);
} else {
- spin_unlock(&lp->lock);
at86rf230_async_read_reg(lp, RG_TRX_STATE, &lp->irq,
at86rf230_rx_trac_check, true);
}
@@ -964,9 +958,7 @@
u8 *buf = ctx->buf;
int rc;
- spin_lock(&lp->lock);
lp->is_tx = 1;
- spin_unlock(&lp->lock);
buf[0] = CMD_FB | CMD_WRITE;
buf[1] = skb->len + 2;
@@ -1698,7 +1690,6 @@
if (rc < 0)
goto free_dev;
- spin_lock_init(&lp->lock);
init_completion(&lp->state_complete);
spi_set_drvdata(spi, lp);