e1000e: do not schedule the Tx queue until ready
Start the Tx queue when the interface is brought up in e1000e_up() but do
not schedule the queue until link is up as detected in the watchdog task
which sets netif_carrier_on.
Also flush the descriptors and clean the Tx and Rx rings before resetting
the hardware when bringing the interface down otherwise there is a small
window where the watchdog task can be triggered with netif_carrier_off
and the Tx ring not yet empty which causes an additional and unnecessary
reset.
Signed-off-by: Bruce Allan <bruce.w.allan@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
diff --git a/drivers/net/e1000e/netdev.c b/drivers/net/e1000e/netdev.c
index c4a23c7..bc99458 100644
--- a/drivers/net/e1000e/netdev.c
+++ b/drivers/net/e1000e/netdev.c
@@ -3347,7 +3347,7 @@
e1000_configure_msix(adapter);
e1000_irq_enable(adapter);
- netif_wake_queue(adapter->netdev);
+ netif_start_queue(adapter->netdev);
/* fire a link change interrupt to start the watchdog */
if (adapter->msix_entries)
@@ -3414,17 +3414,16 @@
e1000e_update_stats(adapter);
spin_unlock(&adapter->stats64_lock);
+ e1000e_flush_descriptors(adapter);
+ e1000_clean_tx_ring(adapter);
+ e1000_clean_rx_ring(adapter);
+
adapter->link_speed = 0;
adapter->link_duplex = 0;
if (!pci_channel_offline(adapter->pdev))
e1000e_reset(adapter);
- e1000e_flush_descriptors(adapter);
-
- e1000_clean_tx_ring(adapter);
- e1000_clean_rx_ring(adapter);
-
/*
* TODO: for power management, we could drop the link and
* pci_disable_device here.