net: fec: Support phys probed from devicetree and fixed-link
This adds support for specifying the phy to be used with the fec in the
devicetree using the standard phy-handle property and also supports
fixed-link.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/Documentation/devicetree/bindings/net/fsl-fec.txt b/Documentation/devicetree/bindings/net/fsl-fec.txt
index 6bc84ad..8a2c7b5 100644
--- a/Documentation/devicetree/bindings/net/fsl-fec.txt
+++ b/Documentation/devicetree/bindings/net/fsl-fec.txt
@@ -12,7 +12,14 @@
only if property "phy-reset-gpios" is available. Missing the property
will have the duration be 1 millisecond. Numbers greater than 1000 are
invalid and 1 millisecond will be used instead.
-- phy-supply: regulator that powers the Ethernet PHY.
+- phy-supply : regulator that powers the Ethernet PHY.
+- phy-handle : phandle to the PHY device connected to this device.
+- fixed-link : Assume a fixed link. See fixed-link.txt in the same directory.
+ Use instead of phy-handle.
+
+Optional subnodes:
+- mdio : specifies the mdio bus in the FEC, used as a container for phy nodes
+ according to phy.txt in the same directory
Example:
@@ -25,3 +32,23 @@
local-mac-address = [00 04 9F 01 1B B9];
phy-supply = <®_fec_supply>;
};
+
+Example with phy specified:
+
+ethernet@83fec000 {
+ compatible = "fsl,imx51-fec", "fsl,imx27-fec";
+ reg = <0x83fec000 0x4000>;
+ interrupts = <87>;
+ phy-mode = "mii";
+ phy-reset-gpios = <&gpio2 14 0>; /* GPIO2_14 */
+ local-mac-address = [00 04 9F 01 1B B9];
+ phy-supply = <®_fec_supply>;
+ phy-handle = <ðphy>;
+ mdio {
+ ethphy: ethernet-phy@6 {
+ compatible = "ethernet-phy-ieee802.3-c22";
+ reg = <6>;
+ max-speed = <100>;
+ };
+ };
+};