ahci: move host flags over to pi.private_data
Private pi.flags area is full and we need more private flags. Move
host private flags over to pi.private_data. During initialization,
these flags are copied to hpriv->flags.
Signed-off-by: Tejun Heo <htejun@gmail.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/ata/ahci.c b/drivers/ata/ahci.c
index b697da4..35ede5c 100644
--- a/drivers/ata/ahci.c
+++ b/drivers/ata/ahci.c
@@ -169,14 +169,16 @@
PORT_CMD_ICC_PARTIAL = (0x2 << 28), /* Put i/f in partial state */
PORT_CMD_ICC_SLUMBER = (0x6 << 28), /* Put i/f in slumber state */
+ /* hpriv->flags bits */
+ AHCI_HFLAG_NO_NCQ = (1 << 0),
+ AHCI_HFLAG_IGN_IRQ_IF_ERR = (1 << 1), /* ignore IRQ_IF_ERR */
+ AHCI_HFLAG_IGN_SERR_INTERNAL = (1 << 2), /* ignore SERR_INTERNAL */
+ AHCI_HFLAG_32BIT_ONLY = (1 << 3), /* force 32bit */
+ AHCI_HFLAG_MV_PATA = (1 << 4), /* PATA port */
+ AHCI_HFLAG_NO_MSI = (1 << 5), /* no PCI MSI */
+
/* ap->flags bits */
- AHCI_FLAG_NO_NCQ = (1 << 24),
- AHCI_FLAG_IGN_IRQ_IF_ERR = (1 << 25), /* ignore IRQ_IF_ERR */
- AHCI_FLAG_IGN_SERR_INTERNAL = (1 << 27), /* ignore SERR_INTERNAL */
- AHCI_FLAG_32BIT_ONLY = (1 << 28), /* force 32bit */
- AHCI_FLAG_MV_PATA = (1 << 29), /* PATA port */
- AHCI_FLAG_NO_MSI = (1 << 30), /* no PCI MSI */
- AHCI_FLAG_NO_HOTPLUG = (1 << 31), /* ignore PxSERR.DIAG.N */
+ AHCI_FLAG_NO_HOTPLUG = (1 << 24), /* ignore PxSERR.DIAG.N */
AHCI_FLAG_COMMON = ATA_FLAG_SATA | ATA_FLAG_NO_LEGACY |
ATA_FLAG_MMIO | ATA_FLAG_PIO_DMA |
@@ -200,6 +202,7 @@
};
struct ahci_host_priv {
+ unsigned int flags; /* AHCI_HFLAG_* */
u32 cap; /* cap to use */
u32 port_map; /* port map to use */
u32 saved_cap; /* saved initial cap */
@@ -341,6 +344,8 @@
.port_stop = ahci_port_stop,
};
+#define AHCI_HFLAGS(flags) .private_data = (void *)(flags)
+
static const struct ata_port_info ahci_port_info[] = {
/* board_ahci */
{
@@ -352,7 +357,8 @@
},
/* board_ahci_vt8251 */
{
- .flags = AHCI_FLAG_COMMON | AHCI_FLAG_NO_NCQ,
+ AHCI_HFLAGS (AHCI_HFLAG_NO_NCQ),
+ .flags = AHCI_FLAG_COMMON,
.link_flags = AHCI_LFLAG_COMMON | ATA_LFLAG_HRST_TO_RESUME,
.pio_mask = 0x1f, /* pio0-4 */
.udma_mask = ATA_UDMA6,
@@ -360,7 +366,8 @@
},
/* board_ahci_ign_iferr */
{
- .flags = AHCI_FLAG_COMMON | AHCI_FLAG_IGN_IRQ_IF_ERR,
+ AHCI_HFLAGS (AHCI_HFLAG_IGN_IRQ_IF_ERR),
+ .flags = AHCI_FLAG_COMMON,
.link_flags = AHCI_LFLAG_COMMON,
.pio_mask = 0x1f, /* pio0-4 */
.udma_mask = ATA_UDMA6,
@@ -368,9 +375,9 @@
},
/* board_ahci_sb600 */
{
- .flags = AHCI_FLAG_COMMON |
- AHCI_FLAG_IGN_SERR_INTERNAL |
- AHCI_FLAG_32BIT_ONLY,
+ AHCI_HFLAGS (AHCI_HFLAG_IGN_SERR_INTERNAL |
+ AHCI_HFLAG_32BIT_ONLY),
+ .flags = AHCI_FLAG_COMMON,
.link_flags = AHCI_LFLAG_COMMON,
.pio_mask = 0x1f, /* pio0-4 */
.udma_mask = ATA_UDMA6,
@@ -378,11 +385,10 @@
},
/* board_ahci_mv */
{
- .sht = &ahci_sht,
+ AHCI_HFLAGS (AHCI_HFLAG_NO_NCQ | AHCI_HFLAG_NO_MSI |
+ AHCI_HFLAG_MV_PATA),
.flags = ATA_FLAG_SATA | ATA_FLAG_NO_LEGACY |
- ATA_FLAG_MMIO | ATA_FLAG_PIO_DMA |
- AHCI_FLAG_NO_NCQ | AHCI_FLAG_NO_MSI |
- AHCI_FLAG_MV_PATA,
+ ATA_FLAG_MMIO | ATA_FLAG_PIO_DMA,
.link_flags = AHCI_LFLAG_COMMON,
.pio_mask = 0x1f, /* pio0-4 */
.udma_mask = ATA_UDMA6,
@@ -534,7 +540,6 @@
/**
* ahci_save_initial_config - Save and fixup initial config values
* @pdev: target PCI device
- * @pi: associated ATA port info
* @hpriv: host private area to store config values
*
* Some registers containing configuration info might be setup by
@@ -548,7 +553,6 @@
* None.
*/
static void ahci_save_initial_config(struct pci_dev *pdev,
- const struct ata_port_info *pi,
struct ahci_host_priv *hpriv)
{
void __iomem *mmio = pcim_iomap_table(pdev)[AHCI_PCI_BAR];
@@ -562,13 +566,13 @@
hpriv->saved_port_map = port_map = readl(mmio + HOST_PORTS_IMPL);
/* some chips have errata preventing 64bit use */
- if ((cap & HOST_CAP_64) && (pi->flags & AHCI_FLAG_32BIT_ONLY)) {
+ if ((cap & HOST_CAP_64) && (hpriv->flags & AHCI_HFLAG_32BIT_ONLY)) {
dev_printk(KERN_INFO, &pdev->dev,
"controller can't do 64bit DMA, forcing 32bit\n");
cap &= ~HOST_CAP_64;
}
- if ((cap & HOST_CAP_NCQ) && (pi->flags & AHCI_FLAG_NO_NCQ)) {
+ if ((cap & HOST_CAP_NCQ) && (hpriv->flags & AHCI_HFLAG_NO_NCQ)) {
dev_printk(KERN_INFO, &pdev->dev,
"controller can't do NCQ, turning off CAP_NCQ\n");
cap &= ~HOST_CAP_NCQ;
@@ -579,7 +583,7 @@
* is asserted through the standard AHCI port
* presence register, as bit 4 (counting from 0)
*/
- if (pi->flags & AHCI_FLAG_MV_PATA) {
+ if (hpriv->flags & AHCI_HFLAG_MV_PATA) {
dev_printk(KERN_ERR, &pdev->dev,
"MV_AHCI HACK: port_map %x -> %x\n",
hpriv->port_map,
@@ -919,13 +923,14 @@
static void ahci_init_controller(struct ata_host *host)
{
+ struct ahci_host_priv *hpriv = host->private_data;
struct pci_dev *pdev = to_pci_dev(host->dev);
void __iomem *mmio = host->iomap[AHCI_PCI_BAR];
int i;
void __iomem *port_mmio;
u32 tmp;
- if (host->ports[0]->flags & AHCI_FLAG_MV_PATA) {
+ if (hpriv->flags & AHCI_HFLAG_MV_PATA) {
port_mmio = __ahci_port_base(host, 4);
writel(0, port_mmio + PORT_IRQ_MASK);
@@ -1307,6 +1312,7 @@
static void ahci_error_intr(struct ata_port *ap, u32 irq_stat)
{
+ struct ahci_host_priv *hpriv = ap->host->private_data;
struct ahci_port_priv *pp = ap->private_data;
struct ata_eh_info *host_ehi = &ap->link.eh_info;
struct ata_link *link = NULL;
@@ -1334,7 +1340,7 @@
host_ehi->serror |= serror;
/* some controllers set IRQ_IF_ERR on device errors, ignore it */
- if (ap->flags & AHCI_FLAG_IGN_IRQ_IF_ERR)
+ if (hpriv->flags & AHCI_HFLAG_IGN_IRQ_IF_ERR)
irq_stat &= ~PORT_IRQ_IF_ERR;
if (irq_stat & PORT_IRQ_TF_ERR) {
@@ -1347,7 +1353,7 @@
else
active_ehi->err_mask |= AC_ERR_DEV;
- if (ap->flags & AHCI_FLAG_IGN_SERR_INTERNAL)
+ if (hpriv->flags & AHCI_HFLAG_IGN_SERR_INTERNAL)
host_ehi->serror &= ~SERR_INTERNAL;
}
@@ -1977,15 +1983,16 @@
if (rc)
return rc;
- if ((pi.flags & AHCI_FLAG_NO_MSI) || pci_enable_msi(pdev))
- pci_intx(pdev, 1);
-
hpriv = devm_kzalloc(dev, sizeof(*hpriv), GFP_KERNEL);
if (!hpriv)
return -ENOMEM;
+ hpriv->flags |= (unsigned long)pi.private_data;
+
+ if ((hpriv->flags & AHCI_HFLAG_NO_MSI) || pci_enable_msi(pdev))
+ pci_intx(pdev, 1);
/* save initial config */
- ahci_save_initial_config(pdev, &pi, hpriv);
+ ahci_save_initial_config(pdev, hpriv);
/* prepare host */
if (hpriv->cap & HOST_CAP_NCQ)