fix printk typo 'faild'
Signed-off-by: Paul Bolle <pebolle@tiscali.nl>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
diff --git a/drivers/net/ps3_gelic_net.c b/drivers/net/ps3_gelic_net.c
index 87d6b8f..49f6700 100644
--- a/drivers/net/ps3_gelic_net.c
+++ b/drivers/net/ps3_gelic_net.c
@@ -642,7 +642,7 @@
status = lv1_net_stop_rx_dma(bus_id(card), dev_id(card), 0);
if (status)
dev_err(ctodev(card),
- "lv1_net_stop_rx_dma faild, %d\n", status);
+ "lv1_net_stop_rx_dma failed, %d\n", status);
}
/**
@@ -660,7 +660,7 @@
status = lv1_net_stop_tx_dma(bus_id(card), dev_id(card), 0);
if (status)
dev_err(ctodev(card),
- "lv1_net_stop_tx_dma faild, status=%d\n", status);
+ "lv1_net_stop_tx_dma failed, status=%d\n", status);
}
/**
diff --git a/drivers/net/tulip/pnic2.c b/drivers/net/tulip/pnic2.c
index b819766..4690c8e 100644
--- a/drivers/net/tulip/pnic2.c
+++ b/drivers/net/tulip/pnic2.c
@@ -59,7 +59,7 @@
* Bit 14:12 - autonegotiation state (write 001 to start autonegotiate)
* Bit 3 - Autopolarity state
* Bit 2 - LS10B - link state of 10baseT 0 - good, 1 - failed
- * Bit 1 - LS100B - link state of 100baseT 0 - good, 1- faild
+ * Bit 1 - LS100B - link state of 100baseT 0 - good, 1 - failed
*
*
* Data Port Selection Info