phy: add set_wol/get_wol functions
This allows ethernet drivers (such as the mv643xx_eth) to support
Wake on LAN on platforms where PHY registers have to be configured
for Wake on LAN (e.g. the Marvell Kirkwood based qnap TS-119P II).
Signed-off-by: Michael Stapelberg <michael@stapelberg.de>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/include/linux/phy.h b/include/linux/phy.h
index 33999ad..9e11039 100644
--- a/include/linux/phy.h
+++ b/include/linux/phy.h
@@ -455,6 +455,14 @@
*/
void (*txtstamp)(struct phy_device *dev, struct sk_buff *skb, int type);
+ /* Some devices (e.g. qnap TS-119P II) require PHY register changes to
+ * enable Wake on LAN, so set_wol is provided to be called in the
+ * ethernet driver's set_wol function. */
+ int (*set_wol)(struct phy_device *dev, struct ethtool_wolinfo *wol);
+
+ /* See set_wol, but for checking whether Wake on LAN is enabled. */
+ void (*get_wol)(struct phy_device *dev, struct ethtool_wolinfo *wol);
+
struct device_driver driver;
};
#define to_phy_driver(d) container_of(d, struct phy_driver, driver)
@@ -560,6 +568,8 @@
int phy_get_eee_err(struct phy_device *phydev);
int phy_ethtool_set_eee(struct phy_device *phydev, struct ethtool_eee *data);
int phy_ethtool_get_eee(struct phy_device *phydev, struct ethtool_eee *data);
+int phy_ethtool_set_wol(struct phy_device *phydev, struct ethtool_wolinfo *wol);
+void phy_ethtool_get_wol(struct phy_device *phydev, struct ethtool_wolinfo *wol);
int __init mdio_bus_init(void);
void mdio_bus_exit(void);