arm: convert pcm037 platform to use smsc911x
Updated to also specify SMSC911X_FORCE_INTERNAL_PHY, as the external phy
detection hardware strap is incorrectly pulled high on this platform.
Signed-off-by: Steve Glendinning <steve.glendinning@smsc.com>
Acked-by: Sascha Hauer <s.hauer@pengutronix.de>
Tested-by: Sascha Hauer <s.hauer@pengutronix.de>
diff --git a/arch/arm/mach-mx3/pcm037.c b/arch/arm/mach-mx3/pcm037.c
index 5fce022..c3648ef 100644
--- a/arch/arm/mach-mx3/pcm037.c
+++ b/arch/arm/mach-mx3/pcm037.c
@@ -24,7 +24,7 @@
#include <linux/mtd/plat-ram.h>
#include <linux/memory.h>
#include <linux/gpio.h>
-#include <linux/smc911x.h>
+#include <linux/smsc911x.h>
#include <linux/interrupt.h>
#include <linux/i2c.h>
#include <linux/i2c/at24.h>
@@ -70,7 +70,7 @@
.flags = IMXUART_HAVE_RTSCTS,
};
-static struct resource smc911x_resources[] = {
+static struct resource smsc911x_resources[] = {
[0] = {
.start = CS1_BASE_ADDR + 0x300,
.end = CS1_BASE_ADDR + 0x300 + SZ_64K - 1,
@@ -79,22 +79,25 @@
[1] = {
.start = IOMUX_TO_IRQ(MX31_PIN_GPIO3_1),
.end = IOMUX_TO_IRQ(MX31_PIN_GPIO3_1),
- .flags = IORESOURCE_IRQ,
+ .flags = IORESOURCE_IRQ | IORESOURCE_IRQ_LOWLEVEL,
},
};
-static struct smc911x_platdata smc911x_info = {
- .flags = SMC911X_USE_32BIT,
- .irq_flags = IRQF_SHARED | IRQF_TRIGGER_LOW,
+static struct smsc911x_platform_config smsc911x_info = {
+ .flags = SMSC911X_USE_32BIT | SMSC911X_FORCE_INTERNAL_PHY |
+ SMSC911X_SAVE_MAC_ADDRESS,
+ .irq_polarity = SMSC911X_IRQ_POLARITY_ACTIVE_LOW,
+ .irq_type = SMSC911X_IRQ_TYPE_OPEN_DRAIN,
+ .phy_interface = PHY_INTERFACE_MODE_MII,
};
static struct platform_device pcm037_eth = {
- .name = "smc911x",
+ .name = "smsc911x",
.id = -1,
- .num_resources = ARRAY_SIZE(smc911x_resources),
- .resource = smc911x_resources,
+ .num_resources = ARRAY_SIZE(smsc911x_resources),
+ .resource = smsc911x_resources,
.dev = {
- .platform_data = &smc911x_info,
+ .platform_data = &smsc911x_info,
},
};