memstick: remove deprecated use of pci api

Replace occurences of the pci api by appropriate call to the dma api.

A simplified version of the semantic patch that finds this problem is as
follows: (http://coccinelle.lip6.fr)

@deprecated@
idexpression id;
position p;
@@

(
  pci_dma_supported@p ( id, ...)
|
  pci_alloc_consistent@p ( id, ...)
)

@bad1@
idexpression id;
position deprecated.p;
@@
...when != &id->dev
   when != pci_get_drvdata ( id )
   when != pci_enable_device ( id )
(
  pci_dma_supported@p ( id, ...)
|
  pci_alloc_consistent@p ( id, ...)
)

@depends on !bad1@
idexpression id;
expression direction;
position deprecated.p;
@@

(
- pci_dma_supported@p ( id,
+ dma_supported ( &id->dev,
...
+ , GFP_ATOMIC
  )
|
- pci_alloc_consistent@p ( id,
+ dma_alloc_coherent ( &id->dev,
...
+ , GFP_ATOMIC
  )
)

Signed-off-by: Quentin Lambert <lambert.quentin@gmail.com>
Cc: Maxim Levitsky <maximlevitsky@gmail.com>
Cc: Greg KH <greg@kroah.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/drivers/memstick/host/jmb38x_ms.c b/drivers/memstick/host/jmb38x_ms.c
index aeabaa5..48db922 100644
--- a/drivers/memstick/host/jmb38x_ms.c
+++ b/drivers/memstick/host/jmb38x_ms.c
@@ -419,10 +419,10 @@
 	}
 
 	if (host->cmd_flags & DMA_DATA) {
-		if (1 != pci_map_sg(host->chip->pdev, &host->req->sg, 1,
+		if (1 != dma_map_sg(&host->chip->pdev->dev, &host->req->sg, 1,
 				    host->req->data_dir == READ
-				    ? PCI_DMA_FROMDEVICE
-				    : PCI_DMA_TODEVICE)) {
+				    ? DMA_FROM_DEVICE
+				    : DMA_TO_DEVICE)) {
 			host->req->error = -ENOMEM;
 			return host->req->error;
 		}
@@ -487,9 +487,9 @@
 	writel(0, host->addr + DMA_CONTROL);
 
 	if (host->cmd_flags & DMA_DATA) {
-		pci_unmap_sg(host->chip->pdev, &host->req->sg, 1,
+		dma_unmap_sg(&host->chip->pdev->dev, &host->req->sg, 1,
 			     host->req->data_dir == READ
-			     ? PCI_DMA_FROMDEVICE : PCI_DMA_TODEVICE);
+			     ? DMA_FROM_DEVICE : DMA_TO_DEVICE);
 	} else {
 		t_val = readl(host->addr + INT_STATUS_ENABLE);
 		if (host->req->data_dir == READ)
@@ -925,7 +925,7 @@
 	int pci_dev_busy = 0;
 	int rc, cnt;
 
-	rc = pci_set_dma_mask(pdev, DMA_BIT_MASK(32));
+	rc = dma_set_mask(&pdev->dev, DMA_BIT_MASK(32));
 	if (rc)
 		return rc;