OMAP2+: hwmod: allow board files to prevent devices from being reset upon init
Some boards can't tolerate IP blocks being reset when they are initialized.
Michael Büsch cites a case with the Nokia N810:
http://www.spinics.net/lists/linux-omap/msg47277.html
To allow such boards to continue working normally, allow board file
maintainers to mark IP blocks to prevent them from being reset upon
init. This is done via a hwmod function, omap_hwmod_no_setup_reset().
Signed-off-by: Paul Walmsley <paul@pwsan.com>
Cc: Michael Buesch <mb@bu3sch.de>
diff --git a/arch/arm/mach-omap2/omap_hwmod.c b/arch/arm/mach-omap2/omap_hwmod.c
index e282e35..816aeb9 100644
--- a/arch/arm/mach-omap2/omap_hwmod.c
+++ b/arch/arm/mach-omap2/omap_hwmod.c
@@ -2218,3 +2218,29 @@
return ret;
}
+
+/**
+ * omap_hwmod_no_setup_reset - prevent a hwmod from being reset upon setup
+ * @oh: struct omap_hwmod *
+ *
+ * Prevent the hwmod @oh from being reset during the setup process.
+ * Intended for use by board-*.c files on boards with devices that
+ * cannot tolerate being reset. Must be called before the hwmod has
+ * been set up. Returns 0 upon success or negative error code upon
+ * failure.
+ */
+int omap_hwmod_no_setup_reset(struct omap_hwmod *oh)
+{
+ if (!oh)
+ return -EINVAL;
+
+ if (oh->_state != _HWMOD_STATE_REGISTERED) {
+ pr_err("omap_hwmod: %s: cannot prevent setup reset; in wrong state\n",
+ oh->name);
+ return -EINVAL;
+ }
+
+ oh->flags |= HWMOD_INIT_NO_RESET;
+
+ return 0;
+}