diff --git a/drivers/isdn/hisax/sedlbauer_cs.c b/drivers/isdn/hisax/sedlbauer_cs.c
index 791e23a..b69eccf 100644
--- a/drivers/isdn/hisax/sedlbauer_cs.c
+++ b/drivers/isdn/hisax/sedlbauer_cs.c
@@ -164,33 +164,11 @@
 static int sedlbauer_config_check(struct pcmcia_device *p_dev,
 				  cistpl_cftable_entry_t *cfg,
 				  cistpl_cftable_entry_t *dflt,
-				  unsigned int vcc,
 				  void *priv_data)
 {
 	if (cfg->index == 0)
 		return -ENODEV;
 
-	/* Does this card need audio output? */
-	if (cfg->flags & CISTPL_CFTABLE_AUDIO)
-		p_dev->config_flags |= CONF_ENABLE_SPKR;
-
-	/* Use power settings for Vcc and Vpp if present */
-	/*  Note that the CIS values need to be rescaled */
-	if (cfg->vcc.present & (1<<CISTPL_POWER_VNOM)) {
-		if (vcc != cfg->vcc.param[CISTPL_POWER_VNOM]/10000)
-			return -ENODEV;
-	} else if (dflt->vcc.present & (1<<CISTPL_POWER_VNOM)) {
-		if (vcc != dflt->vcc.param[CISTPL_POWER_VNOM]/10000)
-			return -ENODEV;
-	}
-
-	if (cfg->vpp1.present & (1<<CISTPL_POWER_VNOM))
-		p_dev->vpp = cfg->vpp1.param[CISTPL_POWER_VNOM]/10000;
-	else if (dflt->vpp1.present & (1<<CISTPL_POWER_VNOM))
-		p_dev->vpp = dflt->vpp1.param[CISTPL_POWER_VNOM]/10000;
-
-	p_dev->config_flags |= CONF_ENABLE_IRQ;
-
 	/* IO window settings */
 	p_dev->resource[0]->end = p_dev->resource[1]->end = 0;
 	if ((cfg->io.nwin > 0) || (dflt->io.nwin > 0)) {
@@ -223,6 +201,9 @@
 
     dev_dbg(&link->dev, "sedlbauer_config(0x%p)\n", link);
 
+    link->config_flags |= CONF_ENABLE_IRQ | CONF_AUTO_CHECK_VCC |
+	    CONF_AUTO_SET_VPP | CONF_AUTO_AUDIO;
+
     /*
       In this loop, we scan the CIS for configuration table entries,
       each of which describes a valid card configuration, including