pcmcia: introduce autoconfiguration feature

Introduce an autoconfiguration feature to set certain values in
pcmcia_loop_config(), instead of copying the same code over and over
in each PCMCIA driver. At first, introduce the following options:

CONF_AUTO_CHECK_VCC	check or matching Vcc entry
CONF_AUTO_SET_VPP	set Vpp
CONF_AUTO_AUDIO		enable the speaker line

CC: netdev@vger.kernel.org
CC: linux-wireless@vger.kernel.org
CC: linux-ide@vger.kernel.org
CC: linux-usb@vger.kernel.org
CC: laforge@gnumonks.org
CC: linux-mtd@lists.infradead.org
CC: alsa-devel@alsa-project.org
CC: linux-serial@vger.kernel.org
CC: Jiri Kosina <jkosina@suse.cz>
CC: linux-scsi@vger.kernel.org
Acked-by: Gustavo F. Padovan <padovan@profusion.mobi> (for drivers/bluetooth)
Tested-by: Wolfram Sang <w.sang@pengutronix.de>
Signed-off-by: Dominik Brodowski <linux@dominikbrodowski.net>
diff --git a/drivers/net/wireless/atmel_cs.c b/drivers/net/wireless/atmel_cs.c
index 080266e..812decd 100644
--- a/drivers/net/wireless/atmel_cs.c
+++ b/drivers/net/wireless/atmel_cs.c
@@ -157,25 +157,11 @@
 static int atmel_config_check(struct pcmcia_device *p_dev,
 			      cistpl_cftable_entry_t *cfg,
 			      cistpl_cftable_entry_t *dflt,
-			      unsigned int vcc,
 			      void *priv_data)
 {
 	if (cfg->index == 0)
 		return -ENODEV;
 
-	/* Does this card need audio output? */
-	if (cfg->flags & CISTPL_CFTABLE_AUDIO)
-		p_dev->config_flags |= CONF_ENABLE_SPKR;
-
-	/* Use power settings for Vcc and Vpp if present */
-	/*  Note that the CIS values need to be rescaled */
-	if (cfg->vpp1.present & (1<<CISTPL_POWER_VNOM))
-		p_dev->vpp = cfg->vpp1.param[CISTPL_POWER_VNOM]/10000;
-	else if (dflt->vpp1.present & (1<<CISTPL_POWER_VNOM))
-		p_dev->vpp = dflt->vpp1.param[CISTPL_POWER_VNOM]/10000;
-
-	p_dev->config_flags |= CONF_ENABLE_IRQ;
-
 	/* IO window settings */
 	p_dev->resource[0]->end = p_dev->resource[1]->end = 0;
 	if ((cfg->io.nwin > 0) || (dflt->io.nwin > 0)) {
@@ -207,6 +193,9 @@
 
 	dev_dbg(&link->dev, "atmel_config\n");
 
+	link->config_flags |= CONF_ENABLE_IRQ | CONF_AUTO_SET_VPP |
+		CONF_AUTO_AUDIO;
+
 	/*
 	  In this loop, we scan the CIS for configuration table entries,
 	  each of which describes a valid card configuration, including