md: Use revalidate_disk to effect changes in size of device.
As revalidate_disk calls check_disk_size_change, it will cause
any capacity change of a gendisk to be propagated to the blockdev
inode. So use that instead of mucking about with locks and
i_size_write.
Also add a call to revalidate_disk in do_md_run and a few other places
where the gendisk capacity is changed.
Signed-off-by: NeilBrown <neilb@suse.de>
diff --git a/drivers/md/raid5.c b/drivers/md/raid5.c
index 2dc35b4..2b521ee 100644
--- a/drivers/md/raid5.c
+++ b/drivers/md/raid5.c
@@ -4858,6 +4858,7 @@
return -EINVAL;
set_capacity(mddev->gendisk, mddev->array_sectors);
mddev->changed = 1;
+ revalidate_disk(mddev->gendisk);
if (sectors > mddev->dev_sectors && mddev->recovery_cp == MaxSector) {
mddev->recovery_cp = mddev->dev_sectors;
set_bit(MD_RECOVERY_NEEDED, &mddev->recovery);
@@ -5058,7 +5059,6 @@
*/
static void raid5_finish_reshape(mddev_t *mddev)
{
- struct block_device *bdev;
raid5_conf_t *conf = mddev->private;
if (!test_bit(MD_RECOVERY_INTR, &mddev->recovery)) {
@@ -5067,15 +5067,7 @@
md_set_array_sectors(mddev, raid5_size(mddev, 0, 0));
set_capacity(mddev->gendisk, mddev->array_sectors);
mddev->changed = 1;
-
- bdev = bdget_disk(mddev->gendisk, 0);
- if (bdev) {
- mutex_lock(&bdev->bd_inode->i_mutex);
- i_size_write(bdev->bd_inode,
- (loff_t)mddev->array_sectors << 9);
- mutex_unlock(&bdev->bd_inode->i_mutex);
- bdput(bdev);
- }
+ revalidate_disk(mddev->gendisk);
} else {
int d;
mddev->degraded = conf->raid_disks;