Blackfin: bf533-ezkit: enable flash drivers by default
This board has a JEDEC ST PSD4256G6V flash device, so enable all the
options needed so it gets probed by default.
Signed-off-by: Mike Frysinger <vapier@gentoo.org>
Signed-off-by: Bob Liu <lliubbo@gmail.com>
diff --git a/arch/blackfin/configs/BF533-EZKIT_defconfig b/arch/blackfin/configs/BF533-EZKIT_defconfig
index 127f20d..16273a9 100644
--- a/arch/blackfin/configs/BF533-EZKIT_defconfig
+++ b/arch/blackfin/configs/BF533-EZKIT_defconfig
@@ -52,10 +52,13 @@
CONFIG_MTD=y
CONFIG_MTD_CHAR=m
CONFIG_MTD_BLOCK=y
-CONFIG_MTD_JEDECPROBE=m
+CONFIG_MTD_JEDECPROBE=y
+CONFIG_MTD_CFI_AMDSTD=y
CONFIG_MTD_RAM=y
-CONFIG_MTD_ROM=m
+CONFIG_MTD_ROM=y
CONFIG_MTD_COMPLEX_MAPPINGS=y
+CONFIG_MTD_PHYSMAP=y
+CONFIG_MTD_PLATRAM=y
CONFIG_BLK_DEV_RAM=y
CONFIG_NETDEVICES=y
# CONFIG_NET_VENDOR_BROADCOM is not set