mac80211: split off mesh handling entirely
This patch splits off mesh handling from the STA/IBSS.
Unfortunately it increases mesh code size a bit, but I
think it makes things clearer. The patch also reduces
per-interface run-time memory usage.
Also clean up a few places where ifdef is not required.
Signed-off-by: Johannes Berg <johannes@sipsolutions.net>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/net/mac80211/mesh_plink.c b/net/mac80211/mesh_plink.c
index 7356462..990a4b7 100644
--- a/net/mac80211/mesh_plink.c
+++ b/net/mac80211/mesh_plink.c
@@ -36,11 +36,11 @@
#define MESH_SECURITY_AUTHENTICATION_IMPOSSIBLE 9
#define MESH_SECURITY_FAILED_VERIFICATION 10
-#define dot11MeshMaxRetries(s) (s->u.sta.mshcfg.dot11MeshMaxRetries)
-#define dot11MeshRetryTimeout(s) (s->u.sta.mshcfg.dot11MeshRetryTimeout)
-#define dot11MeshConfirmTimeout(s) (s->u.sta.mshcfg.dot11MeshConfirmTimeout)
-#define dot11MeshHoldingTimeout(s) (s->u.sta.mshcfg.dot11MeshHoldingTimeout)
-#define dot11MeshMaxPeerLinks(s) (s->u.sta.mshcfg.dot11MeshMaxPeerLinks)
+#define dot11MeshMaxRetries(s) (s->u.mesh.mshcfg.dot11MeshMaxRetries)
+#define dot11MeshRetryTimeout(s) (s->u.mesh.mshcfg.dot11MeshRetryTimeout)
+#define dot11MeshConfirmTimeout(s) (s->u.mesh.mshcfg.dot11MeshConfirmTimeout)
+#define dot11MeshHoldingTimeout(s) (s->u.mesh.mshcfg.dot11MeshHoldingTimeout)
+#define dot11MeshMaxPeerLinks(s) (s->u.mesh.mshcfg.dot11MeshMaxPeerLinks)
enum plink_frame_type {
PLINK_OPEN = 0,
@@ -63,14 +63,14 @@
static inline
void mesh_plink_inc_estab_count(struct ieee80211_sub_if_data *sdata)
{
- atomic_inc(&sdata->u.sta.mshstats.estab_plinks);
+ atomic_inc(&sdata->u.mesh.mshstats.estab_plinks);
mesh_accept_plinks_update(sdata);
}
static inline
void mesh_plink_dec_estab_count(struct ieee80211_sub_if_data *sdata)
{
- atomic_dec(&sdata->u.sta.mshstats.estab_plinks);
+ atomic_dec(&sdata->u.mesh.mshstats.estab_plinks);
mesh_accept_plinks_update(sdata);
}
@@ -245,8 +245,8 @@
sta->last_rx = jiffies;
sta->supp_rates[local->hw.conf.channel->band] = rates;
if (peer_accepting_plinks && sta->plink_state == PLINK_LISTEN &&
- sdata->u.sta.accepting_plinks &&
- sdata->u.sta.mshcfg.auto_open_plinks)
+ sdata->u.mesh.accepting_plinks &&
+ sdata->u.mesh.mshcfg.auto_open_plinks)
mesh_plink_open(sta);
rcu_read_unlock();