trivial: Kconfig: .ko is normally not included in module names
.ko is normally not included in Kconfig help, make it consistent.
Signed-off-by: Pavel Machek <pavel@ucw.cz>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
diff --git a/drivers/mtd/nand/Kconfig b/drivers/mtd/nand/Kconfig
index 890936d..f327689 100644
--- a/drivers/mtd/nand/Kconfig
+++ b/drivers/mtd/nand/Kconfig
@@ -260,7 +260,7 @@
help
This enables the driver for the NAND flash device found on the
Basler eXcite Smart Camera. If built as a module, the driver
- will be named "excite_nandflash.ko".
+ will be named excite_nandflash.
config MTD_NAND_CAFE
tristate "NAND support for OLPC CAFÉ chip"
@@ -282,7 +282,7 @@
controller is enabled for NAND, and currently requires that
the controller be in MMIO mode.
- If you say "m", the module will be called "cs553x_nand.ko".
+ If you say "m", the module will be called cs553x_nand.
config MTD_NAND_ATMEL
tristate "Support for NAND Flash / SmartMedia on AT91 and AVR32"