trivial: Kconfig: .ko is normally not included in module names
.ko is normally not included in Kconfig help, make it consistent.
Signed-off-by: Pavel Machek <pavel@ucw.cz>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
diff --git a/drivers/s390/net/Kconfig b/drivers/s390/net/Kconfig
index a7745c8..cb909a5 100644
--- a/drivers/s390/net/Kconfig
+++ b/drivers/s390/net/Kconfig
@@ -8,7 +8,7 @@
Select this option if you want to use LCS networking on IBM System z.
This device driver supports Token Ring (IEEE 802.5),
FDDI (IEEE 802.7) and Ethernet.
- To compile as a module, choose M. The module name is lcs.ko.
+ To compile as a module, choose M. The module name is lcs.
If you do not know what it is, it's safe to choose Y.
config CTCM
@@ -21,7 +21,7 @@
It also supports virtual CTCs when running under VM.
This driver also supports channel-to-channel MPC SNA devices.
MPC is an SNA protocol device used by Communication Server for Linux.
- To compile as a module, choose M. The module name is ctcm.ko.
+ To compile as a module, choose M. The module name is ctcm.
To compile into the kernel, choose Y.
If you do not need any channel-to-channel connection, choose N.
@@ -34,7 +34,7 @@
link between VM guests. Using ifconfig a point-to-point connection
can be established to the Linux on IBM System z
running on the other VM guest. To compile as a module, choose M.
- The module name is netiucv.ko. If unsure, choose Y.
+ The module name is netiucv. If unsure, choose Y.
config SMSGIUCV
tristate "IUCV special message support (VM only)"
@@ -50,7 +50,7 @@
This driver supports channel attached CLAW devices.
CLAW is Common Link Access for Workstation. Common devices
that use CLAW are RS/6000s, Cisco Routers (CIP) and 3172 devices.
- To compile as a module, choose M. The module name is claw.ko.
+ To compile as a module, choose M. The module name is claw.
To compile into the kernel, choose Y.
config QETH
@@ -65,14 +65,14 @@
<http://www.ibm.com/developerworks/linux/linux390>
To compile this driver as a module, choose M.
- The module name is qeth.ko.
+ The module name is qeth.
config QETH_L2
tristate "qeth layer 2 device support"
depends on QETH
help
Select this option to be able to run qeth devices in layer 2 mode.
- To compile as a module, choose M. The module name is qeth_l2.ko.
+ To compile as a module, choose M. The module name is qeth_l2.
If unsure, choose y.
config QETH_L3
@@ -80,7 +80,7 @@
depends on QETH
help
Select this option to be able to run qeth devices in layer 3 mode.
- To compile as a module choose M. The module name is qeth_l3.ko.
+ To compile as a module choose M. The module name is qeth_l3.
If unsure, choose Y.
config QETH_IPV6