trivial: Kconfig: .ko is normally not included in module names
.ko is normally not included in Kconfig help, make it consistent.
Signed-off-by: Pavel Machek <pavel@ucw.cz>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
diff --git a/drivers/w1/Kconfig b/drivers/w1/Kconfig
index 9adbb4f..fd2c7bd 100644
--- a/drivers/w1/Kconfig
+++ b/drivers/w1/Kconfig
@@ -8,7 +8,7 @@
If you want W1 support, you should say Y here.
This W1 support can also be built as a module. If so, the module
- will be called wire.ko.
+ will be called wire.
if W1
diff --git a/drivers/w1/masters/Kconfig b/drivers/w1/masters/Kconfig
index 96d2f8e..3195fb8 100644
--- a/drivers/w1/masters/Kconfig
+++ b/drivers/w1/masters/Kconfig
@@ -12,7 +12,7 @@
using Matrox's G400 GPIO pins.
This support is also available as a module. If so, the module
- will be called matrox_w1.ko.
+ will be called matrox_w1.
config W1_MASTER_DS2490
tristate "DS2490 USB <-> W1 transport layer for 1-wire"
@@ -22,7 +22,7 @@
for example DS9490*.
This support is also available as a module. If so, the module
- will be called ds2490.ko.
+ will be called ds2490.
config W1_MASTER_DS2482
tristate "Maxim DS2482 I2C to 1-Wire bridge"
@@ -56,7 +56,7 @@
GPIO pins. This driver uses the GPIO API to control the wire.
This support is also available as a module. If so, the module
- will be called w1-gpio.ko.
+ will be called w1-gpio.
config HDQ_MASTER_OMAP
tristate "OMAP HDQ driver"