drm/i915: Add 180 degree primary plane rotation support
Primary planes support 180 degree rotation. Expose the feature
through rotation drm property.
v2: Calculating linear/tiled offsets based on pipe source width and
height. Added 180 degree rotation support in ironlake_update_plane.
v3: Checking if CRTC is active before issueing update_plane. Added
wait for vblank to make sure we dont overtake page flips. Disabling
FBC since it does not work with rotated planes.
v4: Updated rotation checks for pending flips, fbc disable. Creating
rotation property only for Gen4 onwards. Property resetting as part
of lastclose.
v5: Resetting property in i915_driver_lastclose properly for planes
and crtcs. Fixed linear offset calculation that was off by 1 w.r.t
width in i9xx_update_plane and ironlake_update_plane. Removed tab
based indentation and unnecessary braces in intel_crtc_set_property
and intel_update_fbc. FBC and flip related checks should be done only
for valid crtcs.
v6: Minor nits in FBC disable checks for comments in intel_crtc_set_property
and positioning the disable code in intel_update_fbc.
v7: In case rotation property on inactive crtc is updated, we return
successfully printing debug log as crtc is inactive and only property change
is preserved.
v8: update_plane is changed to update_primary_plane, crtc->fb is changed to
crtc->primary->fb and return value of update_primary_plane is ignored.
v9: added rotation property to primary plane instead of crtc. Removing reset
of rotation property from lastclose. rotation_property is moved to
drm_mode_config, so drm layer will take care of resetting. Adding updation of
fbc when rotation is set to 0. Allowing rotation only if value is
different than old one.
v10: Calling intel_primary_plane_setplane instead of update_primary_plane in
set_property(Daniel).
v11: Using same set_property function for both primary and sprite, Adding
primary plane specific code in the same function (Matt).
v12: Removing disabling/ enabling of fbc from set_property because it is done
from intel_pipe_set_base. Other formatting
v13: we need to call disable_fbc before changing the rotation to 180,
disable_fbc from intel_pipe_set_base gets called very late, that will
be used to re-enable fbc if rotation is set to 0 (Ville).
Testcase: igt/kms_rotation_crc
Signed-off-by: Uma Shankar <uma.shankar@intel.com>
Signed-off-by: Sagar Kamble <sagar.a.kamble@intel.com>
Signed-off-by: Sonika Jindal <sonika.jindal@intel.com>
[danvet: Add FIXME to explain why we need the open-coded update_fbc
hunk to disable fbc when rotated 180 degree. And make checkpatch
happier.]
Acked-by: Matt Roper <matthew.d.roper@intel.com>
Signed-off-by: Daniel Vetter <daniel.vetter@ffwll.ch>
diff --git a/drivers/gpu/drm/i915/i915_reg.h b/drivers/gpu/drm/i915/i915_reg.h
index 203062e..142ac52 100644
--- a/drivers/gpu/drm/i915/i915_reg.h
+++ b/drivers/gpu/drm/i915/i915_reg.h
@@ -4214,6 +4214,7 @@
#define DISPPLANE_NO_LINE_DOUBLE 0
#define DISPPLANE_STEREO_POLARITY_FIRST 0
#define DISPPLANE_STEREO_POLARITY_SECOND (1<<18)
+#define DISPPLANE_ROTATE_180 (1<<15)
#define DISPPLANE_TRICKLE_FEED_DISABLE (1<<14) /* Ironlake */
#define DISPPLANE_TILED (1<<10)
#define _DSPAADDR 0x70184
diff --git a/drivers/gpu/drm/i915/intel_display.c b/drivers/gpu/drm/i915/intel_display.c
index f072b75..ae218e0 100644
--- a/drivers/gpu/drm/i915/intel_display.c
+++ b/drivers/gpu/drm/i915/intel_display.c
@@ -2378,6 +2378,9 @@
unsigned long linear_offset;
u32 dspcntr;
u32 reg = DSPCNTR(plane);
+ int pixel_size;
+
+ pixel_size = drm_format_plane_cpp(fb->pixel_format, 0);
if (!intel_crtc->primary_enabled) {
I915_WRITE(reg, 0);
@@ -2444,8 +2447,6 @@
if (IS_G4X(dev))
dspcntr |= DISPPLANE_TRICKLE_FEED_DISABLE;
- I915_WRITE(reg, dspcntr);
-
linear_offset = y * fb->pitches[0] + x * (fb->bits_per_pixel / 8);
if (INTEL_INFO(dev)->gen >= 4) {
@@ -2458,6 +2459,21 @@
intel_crtc->dspaddr_offset = linear_offset;
}
+ if (to_intel_plane(crtc->primary)->rotation == BIT(DRM_ROTATE_180)) {
+ dspcntr |= DISPPLANE_ROTATE_180;
+
+ x += (intel_crtc->config.pipe_src_w - 1);
+ y += (intel_crtc->config.pipe_src_h - 1);
+
+ /* Finding the last pixel of the last line of the display
+ data and adding to linear_offset*/
+ linear_offset +=
+ (intel_crtc->config.pipe_src_h - 1) * fb->pitches[0] +
+ (intel_crtc->config.pipe_src_w - 1) * pixel_size;
+ }
+
+ I915_WRITE(reg, dspcntr);
+
DRM_DEBUG_KMS("Writing base %08lX %08lX %d %d %d\n",
i915_gem_obj_ggtt_offset(obj), linear_offset, x, y,
fb->pitches[0]);
@@ -2484,6 +2500,9 @@
unsigned long linear_offset;
u32 dspcntr;
u32 reg = DSPCNTR(plane);
+ int pixel_size;
+
+ pixel_size = drm_format_plane_cpp(fb->pixel_format, 0);
if (!intel_crtc->primary_enabled) {
I915_WRITE(reg, 0);
@@ -2532,14 +2551,28 @@
if (!IS_HASWELL(dev) && !IS_BROADWELL(dev))
dspcntr |= DISPPLANE_TRICKLE_FEED_DISABLE;
- I915_WRITE(reg, dspcntr);
-
linear_offset = y * fb->pitches[0] + x * (fb->bits_per_pixel / 8);
intel_crtc->dspaddr_offset =
intel_gen4_compute_page_offset(&x, &y, obj->tiling_mode,
fb->bits_per_pixel / 8,
fb->pitches[0]);
linear_offset -= intel_crtc->dspaddr_offset;
+ if (to_intel_plane(crtc->primary)->rotation == BIT(DRM_ROTATE_180)) {
+ dspcntr |= DISPPLANE_ROTATE_180;
+
+ if (!IS_HASWELL(dev) && !IS_BROADWELL(dev)) {
+ x += (intel_crtc->config.pipe_src_w - 1);
+ y += (intel_crtc->config.pipe_src_h - 1);
+
+ /* Finding the last pixel of the last line of the display
+ data and adding to linear_offset*/
+ linear_offset +=
+ (intel_crtc->config.pipe_src_h - 1) * fb->pitches[0] +
+ (intel_crtc->config.pipe_src_w - 1) * pixel_size;
+ }
+ }
+
+ I915_WRITE(reg, dspcntr);
DRM_DEBUG_KMS("Writing base %08lX %08lX %d %d %d\n",
i915_gem_obj_ggtt_offset(obj), linear_offset, x, y,
@@ -11562,6 +11595,7 @@
uint32_t src_w, uint32_t src_h)
{
struct drm_device *dev = crtc->dev;
+ struct drm_i915_private *dev_priv = dev->dev_private;
struct intel_crtc *intel_crtc = to_intel_crtc(crtc);
struct drm_i915_gem_object *obj = intel_fb_obj(fb);
struct drm_i915_gem_object *old_obj = intel_fb_obj(plane->fb);
@@ -11674,6 +11708,24 @@
mutex_unlock(&dev->struct_mutex);
} else {
+ if (intel_crtc && intel_crtc->active &&
+ intel_crtc->primary_enabled) {
+ /*
+ * FBC does not work on some platforms for rotated
+ * planes, so disable it when rotation is not 0 and
+ * update it when rotation is set back to 0.
+ *
+ * FIXME: This is redundant with the fbc update done in
+ * the primary plane enable function except that that
+ * one is done too late. We eventually need to unify
+ * this.
+ */
+ if (INTEL_INFO(dev)->gen <= 4 && !IS_G4X(dev) &&
+ dev_priv->fbc.plane == intel_crtc->plane &&
+ intel_plane->rotation != BIT(DRM_ROTATE_0)) {
+ intel_disable_fbc(dev);
+ }
+ }
ret = intel_pipe_set_base(crtc, src.x1, src.y1, fb);
if (ret)
return ret;
@@ -11707,6 +11759,7 @@
.update_plane = intel_primary_plane_setplane,
.disable_plane = intel_primary_plane_disable,
.destroy = intel_plane_destroy,
+ .set_property = intel_plane_set_property
};
static struct drm_plane *intel_primary_plane_create(struct drm_device *dev,
@@ -11724,6 +11777,7 @@
primary->max_downscale = 1;
primary->pipe = pipe;
primary->plane = pipe;
+ primary->rotation = BIT(DRM_ROTATE_0);
if (HAS_FBC(dev) && INTEL_INFO(dev)->gen < 4)
primary->plane = !pipe;
@@ -11739,6 +11793,19 @@
&intel_primary_plane_funcs,
intel_primary_formats, num_formats,
DRM_PLANE_TYPE_PRIMARY);
+
+ if (INTEL_INFO(dev)->gen >= 4) {
+ if (!dev->mode_config.rotation_property)
+ dev->mode_config.rotation_property =
+ drm_mode_create_rotation_property(dev,
+ BIT(DRM_ROTATE_0) |
+ BIT(DRM_ROTATE_180));
+ if (dev->mode_config.rotation_property)
+ drm_object_attach_property(&primary->base.base,
+ dev->mode_config.rotation_property,
+ primary->rotation);
+ }
+
return &primary->base;
}
diff --git a/drivers/gpu/drm/i915/intel_drv.h b/drivers/gpu/drm/i915/intel_drv.h
index d683a20..2466b2b 100644
--- a/drivers/gpu/drm/i915/intel_drv.h
+++ b/drivers/gpu/drm/i915/intel_drv.h
@@ -1093,6 +1093,9 @@
int intel_plane_init(struct drm_device *dev, enum pipe pipe, int plane);
void intel_flush_primary_plane(struct drm_i915_private *dev_priv,
enum plane plane);
+int intel_plane_set_property(struct drm_plane *plane,
+ struct drm_property *prop,
+ uint64_t val);
int intel_plane_restore(struct drm_plane *plane);
void intel_plane_disable(struct drm_plane *plane);
int intel_sprite_set_colorkey(struct drm_device *dev, void *data,
diff --git a/drivers/gpu/drm/i915/intel_pm.c b/drivers/gpu/drm/i915/intel_pm.c
index c8f744c..1ab3e11 100644
--- a/drivers/gpu/drm/i915/intel_pm.c
+++ b/drivers/gpu/drm/i915/intel_pm.c
@@ -581,6 +581,12 @@
DRM_DEBUG_KMS("framebuffer not tiled or fenced, disabling compression\n");
goto out_disable;
}
+ if (INTEL_INFO(dev)->gen <= 4 && !IS_G4X(dev) &&
+ to_intel_plane(crtc->primary)->rotation != BIT(DRM_ROTATE_0)) {
+ if (set_no_fbc_reason(dev_priv, FBC_UNSUPPORTED_MODE))
+ DRM_DEBUG_KMS("Rotation unsupported, disabling\n");
+ goto out_disable;
+ }
/* If the kernel debugger is active, always disable compression */
if (in_dbg_master())
diff --git a/drivers/gpu/drm/i915/intel_sprite.c b/drivers/gpu/drm/i915/intel_sprite.c
index 0bdb00b..fd5f271 100644
--- a/drivers/gpu/drm/i915/intel_sprite.c
+++ b/drivers/gpu/drm/i915/intel_sprite.c
@@ -1218,9 +1218,9 @@
return ret;
}
-static int intel_plane_set_property(struct drm_plane *plane,
- struct drm_property *prop,
- uint64_t val)
+int intel_plane_set_property(struct drm_plane *plane,
+ struct drm_property *prop,
+ uint64_t val)
{
struct drm_device *dev = plane->dev;
struct intel_plane *intel_plane = to_intel_plane(plane);
@@ -1249,7 +1249,7 @@
if (!plane->crtc || !plane->fb)
return 0;
- return intel_update_plane(plane, plane->crtc, plane->fb,
+ return plane->funcs->update_plane(plane, plane->crtc, plane->fb,
intel_plane->crtc_x, intel_plane->crtc_y,
intel_plane->crtc_w, intel_plane->crtc_h,
intel_plane->src_x, intel_plane->src_y,