[PATCH] sky2: remove unused definitions
The sky2 driver has a lot of register definitions, that were
copied over from the skge driver, for areas that don't exist
on the Yukon2.
Signed-off-by: Stephen Hemminger <shemminger@osdl.org>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>
diff --git a/drivers/net/sky2.h b/drivers/net/sky2.h
index b1acdc6..c15d464 100644
--- a/drivers/net/sky2.h
+++ b/drivers/net/sky2.h
@@ -85,21 +85,6 @@
B0_IMSK = 0x000c,
B0_HWE_ISRC = 0x0010,
B0_HWE_IMSK = 0x0014,
- B0_SP_ISRC = 0x0018,
- B0_XM1_IMSK = 0x0020,
- B0_XM1_ISRC = 0x0028,
- B0_XM1_PHY_ADDR = 0x0030,
- B0_XM1_PHY_DATA = 0x0034,
- B0_XM2_IMSK = 0x0040,
- B0_XM2_ISRC = 0x0048,
- B0_XM2_PHY_ADDR = 0x0050,
- B0_XM2_PHY_DATA = 0x0054,
- B0_R1_CSR = 0x0060,
- B0_R2_CSR = 0x0064,
- B0_XS1_CSR = 0x0068,
- B0_XA1_CSR = 0x006c,
- B0_XS2_CSR = 0x0070,
- B0_XA2_CSR = 0x0074,
/* Special ISR registers (Yukon-2 only) */
B0_Y2_SP_ISRC2 = 0x001c,
@@ -116,36 +101,25 @@
B2_MAC_CFG = 0x011a,
B2_CHIP_ID = 0x011b,
B2_E_0 = 0x011c,
- B2_E_1 = 0x011d,
- B2_E_2 = 0x011e,
+
B2_Y2_CLK_GATE = 0x011d,
B2_Y2_HW_RES = 0x011e,
B2_E_3 = 0x011f,
B2_Y2_CLK_CTRL = 0x0120,
- B2_LD_CTRL = 0x0128,
- B2_LD_TEST = 0x0129,
+
B2_TI_INI = 0x0130,
B2_TI_VAL = 0x0134,
B2_TI_CTRL = 0x0138,
B2_TI_TEST = 0x0139,
- B2_IRQM_INI = 0x0140,
- B2_IRQM_VAL = 0x0144,
- B2_IRQM_CTRL = 0x0148,
- B2_IRQM_TEST = 0x0149,
- B2_IRQM_MSK = 0x014c,
- B2_IRQM_HWE_MSK = 0x0150,
+
B2_TST_CTRL1 = 0x0158,
B2_TST_CTRL2 = 0x0159,
B2_GP_IO = 0x015c,
+
B2_I2C_CTRL = 0x0160,
B2_I2C_DATA = 0x0164,
B2_I2C_IRQ = 0x0168,
B2_I2C_SW = 0x016c,
- B2_BSC_INI = 0x0170,
- B2_BSC_VAL = 0x0174,
- B2_BSC_CTRL = 0x0178,
- B2_BSC_STAT = 0x0179,
- B2_BSC_TST = 0x017a,
B3_RAM_ADDR = 0x0180,
B3_RAM_DATA_LO = 0x0184,
@@ -220,8 +194,6 @@
Y2_LED_STAT_ON = 1<<9, /* Status LED On (YUKON-2 only) */
Y2_LED_STAT_OFF = 1<<8, /* Status LED Off (YUKON-2 only) */
- CS_BUS_CLOCK = 1<<9, /* Bus Clock 0/1 = 33/66 MHz */
- CS_BUS_SLOT_SZ = 1<<8, /* Slot Size 0/1 = 32/64 bit slot */
CS_ST_SW_IRQ = 1<<7, /* Set IRQ SW Request */
CS_CL_SW_IRQ = 1<<6, /* Clear IRQ SW Request */
CS_STOP_DONE = 1<<5, /* Stop Master is finished */