mac80211: add fast-rx path
The regular RX path has a lot of code, but with a few
assumptions on the hardware it's possible to reduce the
amount of code significantly. Currently the assumptions
on the driver are the following:
* hardware/driver reordering buffer (if supporting aggregation)
* hardware/driver decryption & PN checking (if using encryption)
* hardware/driver did de-duplication
* hardware/driver did A-MSDU deaggregation
* AP_LINK_PS is used (in AP mode)
* no client powersave handling in mac80211 (in client mode)
of which some are actually checked per packet:
* de-duplication
* PN checking
* decryption
and additionally packets must
* not be A-MSDU (have been deaggregated by driver/device)
* be data packets
* not be fragmented
* be unicast
* have RFC 1042 header
Additionally dynamically we assume:
* no encryption or CCMP/GCMP, TKIP/WEP/other not allowed
* station must be authorized
* 4-addr format not enabled
Some data needed for the RX path is cached in a new per-station
"fast_rx" structure, so that we only need to look at this and
the packet, no other memory when processing packets on the fast
RX path.
After doing the above per-packet checks, the data path collapses
down to a pretty simple conversion function taking advantage of
the data cached in the small fast_rx struct.
This should speed up the RX processing, and will make it easier
to reason about parallelizing RX (for which statistics will need
to be per-CPU still.)
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
diff --git a/net/mac80211/cfg.c b/net/mac80211/cfg.c
index 62a90f2..fc4730b 100644
--- a/net/mac80211/cfg.c
+++ b/net/mac80211/cfg.c
@@ -65,11 +65,13 @@
return ret;
if (type == NL80211_IFTYPE_AP_VLAN &&
- params && params->use_4addr == 0)
+ params && params->use_4addr == 0) {
RCU_INIT_POINTER(sdata->u.vlan.sta, NULL);
- else if (type == NL80211_IFTYPE_STATION &&
- params && params->use_4addr >= 0)
+ ieee80211_check_fast_rx_iface(sdata);
+ } else if (type == NL80211_IFTYPE_STATION &&
+ params && params->use_4addr >= 0) {
sdata->u.mgd.use_4addr = params->use_4addr;
+ }
if (sdata->vif.type == NL80211_IFTYPE_MONITOR && flags) {
struct ieee80211_local *local = sdata->local;
@@ -1367,6 +1369,7 @@
rcu_assign_pointer(vlansdata->u.vlan.sta, sta);
new_4addr = true;
+ __ieee80211_check_fast_rx_iface(vlansdata);
}
if (sta->sdata->vif.type == NL80211_IFTYPE_AP_VLAN &&
@@ -1889,6 +1892,7 @@
sdata->flags |= IEEE80211_SDATA_DONT_BRIDGE_PACKETS;
else
sdata->flags &= ~IEEE80211_SDATA_DONT_BRIDGE_PACKETS;
+ ieee80211_check_fast_rx_iface(sdata);
}
if (params->ht_opmode >= 0) {