tty/serial: at91: revise the return type of atmel_init_property
The function of atmel_init_property is to set the work manner of
atmel serial ports according to the property in device trees.
If DMA or PDC is not set or something goes wrong in getting property,
the work manner will switch to general PIO mode, thus there will
not be any failure case in this function. It's actually a procedure.
So changing the return type from int to void.
Signed-off-by: Leilei Zhao <leilei.zhao@atmel.com>
Acked-by: Nicolas Ferre <nicolas.ferre@atmel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/tty/serial/atmel_serial.c b/drivers/tty/serial/atmel_serial.c
index 6b70ec6..a9b2688 100644
--- a/drivers/tty/serial/atmel_serial.c
+++ b/drivers/tty/serial/atmel_serial.c
@@ -1534,7 +1534,7 @@
spin_unlock(&port->lock);
}
-static int atmel_init_property(struct atmel_uart_port *atmel_port,
+static void atmel_init_property(struct atmel_uart_port *atmel_port,
struct platform_device *pdev)
{
struct device_node *np = pdev->dev.of_node;
@@ -1575,7 +1575,6 @@
atmel_port->use_dma_tx = false;
}
- return 0;
}
static void atmel_init_rs485(struct uart_port *port,
@@ -2235,8 +2234,8 @@
struct uart_port *port = &atmel_port->uart;
struct atmel_uart_data *pdata = dev_get_platdata(&pdev->dev);
- if (!atmel_init_property(atmel_port, pdev))
- atmel_set_ops(port);
+ atmel_init_property(atmel_port, pdev);
+ atmel_set_ops(port);
atmel_init_rs485(port, pdev);