qla4xxx: Do not wait for IO completion, after issuing stop_firmware
Problem:
iSCSI stop_firmware mailbox command is not completing outstanding IO.
Solution:
Do not wait for IO completion after issuing stop_firmware mailbox
command
Signed-off-by: Tej Parkash <tej.parkash@qlogic.com>
Signed-off-by: Vikas Chaudhary <vikas.chaudhary@qlogic.com>
Reviewed-by: Mike Christie <michaelc@cs.wisc.edu>
Signed-off-by: Christoph Hellwig <hch@lst.de>
diff --git a/drivers/scsi/qla4xxx/ql4_os.c b/drivers/scsi/qla4xxx/ql4_os.c
index 459b9f7..2e95be4 100644
--- a/drivers/scsi/qla4xxx/ql4_os.c
+++ b/drivers/scsi/qla4xxx/ql4_os.c
@@ -4862,9 +4862,6 @@
ha->host_no, __func__));
status = ha->isp_ops->reset_firmware(ha);
if (status == QLA_SUCCESS) {
- if (!test_bit(AF_FW_RECOVERY, &ha->flags))
- qla4xxx_cmd_wait(ha);
-
ha->isp_ops->disable_intrs(ha);
qla4xxx_process_aen(ha, FLUSH_DDB_CHANGED_AENS);
qla4xxx_abort_active_cmds(ha, DID_RESET << 16);