[SCSI] tmscsim: clean-up status codes
Remove redundant defines from the header, replace all occurances in the
code with standard SAM_STAT_ macros. Also fix what seems to be a typo in
testing for (status == H_OVER_UNDER_RUN)...
Signed-off-by: G. Liakhovetski <g.liakhovetski@gmx.de>
Signed-off-by: James Bottomley <James.Bottomley@SteelEye.com>
diff --git a/drivers/scsi/tmscsim.h b/drivers/scsi/tmscsim.h
index c3d8c80..c74c72a 100644
--- a/drivers/scsi/tmscsim.h
+++ b/drivers/scsi/tmscsim.h
@@ -258,13 +258,6 @@
#define H_BAD_CCB_OR_SG 0x1A
#define H_ABORT 0x0FF
-/*; SCSI Status byte codes*/
-/* The values defined in include/scsi/scsi.h, to be shifted << 1 */
-
-#define SCSI_STAT_UNEXP_BUS_F 0xFD /*; Unexpect Bus Free */
-#define SCSI_STAT_BUS_RST_DETECT 0xFE /*; Scsi Bus Reset detected */
-#define SCSI_STAT_SEL_TIMEOUT 0xFF /*; Selection Time out */
-
/* cmd->result */
#define RES_TARGET 0x000000FF /* Target State */
#define RES_TARGET_LNX STATUS_MASK /* Only official ... */
@@ -273,7 +266,7 @@
#define RES_DRV 0xFF000000 /* DRIVER_ codes */
#define MK_RES(drv,did,msg,tgt) ((int)(drv)<<24 | (int)(did)<<16 | (int)(msg)<<8 | (int)(tgt))
-#define MK_RES_LNX(drv,did,msg,tgt) ((int)(drv)<<24 | (int)(did)<<16 | (int)(msg)<<8 | (int)(tgt)<<1)
+#define MK_RES_LNX(drv,did,msg,tgt) ((int)(drv)<<24 | (int)(did)<<16 | (int)(msg)<<8 | (int)(tgt))
#define SET_RES_TARGET(who, tgt) do { who &= ~RES_TARGET; who |= (int)(tgt); } while (0)
#define SET_RES_TARGET_LNX(who, tgt) do { who &= ~RES_TARGET_LNX; who |= (int)(tgt) << 1; } while (0)