i2c-stu300: Use struct dev_pm_ops for power management
Make the ST-Ericsson U300 I2C controller driver define its PM
callbacks through a struct dev_pm_ops object rather than by using
legacy PM hooks in struct platform_driver.
Signed-off-by: Rafael J. Wysocki <rjw@sisk.pl>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Wolfram Sang <w.sang@pengutronix.de>
diff --git a/drivers/i2c/busses/i2c-stu300.c b/drivers/i2c/busses/i2c-stu300.c
index 79b7851..80dd1c0 100644
--- a/drivers/i2c/busses/i2c-stu300.c
+++ b/drivers/i2c/busses/i2c-stu300.c
@@ -979,31 +979,33 @@
}
#ifdef CONFIG_PM
-static int stu300_suspend(struct platform_device *pdev, pm_message_t state)
+static int stu300_suspend(struct device *device)
{
- struct stu300_dev *dev = platform_get_drvdata(pdev);
+ struct stu300_dev *dev = dev_get_drvdata(device);
/* Turn off everything */
stu300_wr8(0x00, dev->virtbase + I2C_CR);
return 0;
}
-static int stu300_resume(struct platform_device *pdev)
+static int stu300_resume(struct device *device)
{
int ret = 0;
- struct stu300_dev *dev = platform_get_drvdata(pdev);
+ struct stu300_dev *dev = dev_get_drvdata(device);
clk_enable(dev->clk);
ret = stu300_init_hw(dev);
clk_disable(dev->clk);
if (ret != 0)
- dev_err(&pdev->dev, "error re-initializing hardware.\n");
+ dev_err(device, "error re-initializing hardware.\n");
return ret;
}
+
+static SIMPLE_DEV_PM_OPS(stu300_pm, stu300_suspend, stu300_resume);
+#define STU300_I2C_PM (&stu300_pm)
#else
-#define stu300_suspend NULL
-#define stu300_resume NULL
+#define STU300_I2C_PM NULL
#endif
static int __exit
@@ -1028,10 +1030,9 @@
.driver = {
.name = NAME,
.owner = THIS_MODULE,
+ .pm = STU300_I2C_PM,
},
.remove = __exit_p(stu300_remove),
- .suspend = stu300_suspend,
- .resume = stu300_resume,
};