bna: Clear Driver Config Flags When HW Resets
Driver configuration flags are retained across open/stop operations preventing
configurations to be set in next open/stop. Setting MTU on a 1020 causes
network to fail until a reboot is performed on the host.
Clear the flags when configuration resets in hardware.
Signed-off-by: Rasesh Mody <rmody@brocade.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/brocade/bna/bnad.c b/drivers/net/ethernet/brocade/bna/bnad.c
index 07f7ef0..b78e69e 100644
--- a/drivers/net/ethernet/brocade/bna/bnad.c
+++ b/drivers/net/ethernet/brocade/bna/bnad.c
@@ -2624,6 +2624,9 @@
bnad_destroy_tx(bnad, 0);
bnad_destroy_rx(bnad, 0);
+ /* These config flags are cleared in the hardware */
+ bnad->cfg_flags &= ~(BNAD_CF_ALLMULTI | BNAD_CF_PROMISC);
+
/* Synchronize mailbox IRQ */
bnad_mbox_irq_sync(bnad);