USB: ohci-at91 uses generic GPIO calls
Update the ohci-at91 bus glue to start understanding about the per-port
power switch GPIOs it's given (on the sam9263-ek and potentially other
boards). For the moment this just claims them and forces them active
(assuming active-low power enables) whenever the HCD is loaded.
The assumption is still that board setup configures the GPIOs. Using
gpio_request() tracks actual usage and guards against conflict.
Signed-off-by: David Brownell <dbrownell@users.sourceforge.net>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
diff --git a/drivers/usb/host/ohci-at91.c b/drivers/usb/host/ohci-at91.c
index d849c80..126fcbd 100644
--- a/drivers/usb/host/ohci-at91.c
+++ b/drivers/usb/host/ohci-at91.c
@@ -17,6 +17,8 @@
#include <asm/mach-types.h>
#include <asm/hardware.h>
+#include <asm/gpio.h>
+
#include <asm/arch/board.h>
#include <asm/arch/cpu.h>
@@ -271,12 +273,41 @@
static int ohci_hcd_at91_drv_probe(struct platform_device *pdev)
{
+ struct at91_usbh_data *pdata = pdev->dev.platform_data;
+ int i;
+
+ if (pdata) {
+ /* REVISIT make the driver support per-port power switching,
+ * and also overcurrent detection. Here we assume the ports
+ * are always powered while this driver is active, and use
+ * active-low power switches.
+ */
+ for (i = 0; i < pdata->ports; i++) {
+ if (pdata->vbus_pin[i] <= 0)
+ continue;
+ gpio_request(pdata->vbus_pin[i], "ohci_vbus");
+ gpio_direction_output(pdata->vbus_pin[i], 0);
+ }
+ }
+
device_init_wakeup(&pdev->dev, 1);
return usb_hcd_at91_probe(&ohci_at91_hc_driver, pdev);
}
static int ohci_hcd_at91_drv_remove(struct platform_device *pdev)
{
+ struct at91_usbh_data *pdata = pdev->dev.platform_data;
+ int i;
+
+ if (pdata) {
+ for (i = 0; i < pdata->ports; i++) {
+ if (pdata->vbus_pin[i] <= 0)
+ continue;
+ gpio_direction_output(pdata->vbus_pin[i], 1);
+ gpio_free(pdata->vbus_pin[i]);
+ }
+ }
+
device_init_wakeup(&pdev->dev, 0);
return usb_hcd_at91_remove(platform_get_drvdata(pdev), pdev);
}