bcma: init serial console directly from ChipCommon code
UART is connected to and controlled over ChipCommon core. It doesn't
have much to do with MIPS core (where we initialize it currently)
except just existing on embedded systemms. There isn't point of such
cross-core initialization (and we needed #ifdef anyway) so just handle
it in ChipCommon.
Signed-off-by: Rafał Miłecki <zajec5@gmail.com>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>
diff --git a/drivers/bcma/driver_chipcommon.c b/drivers/bcma/driver_chipcommon.c
index 36ee221..bdb73d9 100644
--- a/drivers/bcma/driver_chipcommon.c
+++ b/drivers/bcma/driver_chipcommon.c
@@ -15,6 +15,8 @@
#include <linux/platform_device.h>
#include <linux/bcma/bcma.h>
+static void bcma_chipco_serial_init(struct bcma_drv_cc *cc);
+
static inline u32 bcma_cc_write32_masked(struct bcma_drv_cc *cc, u16 offset,
u32 mask, u32 value)
{
@@ -115,6 +117,8 @@
void bcma_core_chipcommon_early_init(struct bcma_drv_cc *cc)
{
+ struct bcma_bus *bus = cc->core->bus;
+
if (cc->early_setup_done)
return;
@@ -129,6 +133,9 @@
if (cc->capabilities & BCMA_CC_CAP_PMU)
bcma_pmu_early_init(cc);
+ if (IS_BUILTIN(CONFIG_BCM47XX) && bus->hosttype == BCMA_HOSTTYPE_SOC)
+ bcma_chipco_serial_init(cc);
+
cc->early_setup_done = true;
}
@@ -314,9 +321,9 @@
return res;
}
-#ifdef CONFIG_BCMA_DRIVER_MIPS
-void bcma_chipco_serial_init(struct bcma_drv_cc *cc)
+static void bcma_chipco_serial_init(struct bcma_drv_cc *cc)
{
+#if IS_BUILTIN(CONFIG_BCM47XX)
unsigned int irq;
u32 baud_base;
u32 i;
@@ -358,5 +365,5 @@
ports[i].baud_base = baud_base;
ports[i].reg_shift = 0;
}
+#endif /* CONFIG_BCM47XX */
}
-#endif /* CONFIG_BCMA_DRIVER_MIPS */