Merge tag 'integrator-for-arm-soc' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-integrator into next/cleanup

From Linus Walleij <linus.walleij@linaro.org>:

This series will do the following:
- Switch the Integrator/AP and /CP to use the SoC bus
  when booting from device tree.
- Group all devices on the SoC below this bus so as to
  set a good example of how to do this. The bus was
  invented by Lee Jones, let's show how it's to be used
  on a DT:ed SoC.
- Fetch the special system controller offsets from two
  special device tree nodes for each case and replace
  the static mappings with these at boot.
- Move some static remaps to the ATAG-only code path
  and delete some static maps that aren't used.
- Push dependencies on system controller remaps down
  to the Integrator/AP board file and the PCIv3 driver
  respectively and use only dynamic remappings.
- Fix up conditional BUG() usage in the PCIv3 driver
  to be simpler and more to the point.

* tag 'integrator-for-arm-soc' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-integrator:
  ARM: integrator: use BUG_ON where possible
  ARM: integrator: push down SC dependencies
  ARM: integrator: delete static UART1 mapping
  ARM: integrator: delete SC mapping on the CP
  ARM: integrator: remove static CP syscon mapping
  ARM: integrator: remove static AP syscon mapping
  ARM: integrator: hook the CP into the SoC bus
  ARM: integrator: hook the AP into the SoC bus

Signed-off-by: Arnd Bergmann <arnd@arndb.de>