mtd: omap2: fix some typos in comments
Signed-off-by: Peter Meerwald <p.meerwald@bct-electronic.com>
Signed-off-by: Artem Bityutskiy <artem.bityutskiy@linux.intel.com>
Signed-off-by: David Woodhouse <David.Woodhouse@intel.com>
diff --git a/drivers/mtd/nand/omap2.c b/drivers/mtd/nand/omap2.c
index ac4fd75..1ede9fb 100644
--- a/drivers/mtd/nand/omap2.c
+++ b/drivers/mtd/nand/omap2.c
@@ -347,7 +347,7 @@
}
/*
- * omap_nand_dma_transfer: configer and start dma transfer
+ * omap_nand_dma_transfer: configure and start dma transfer
* @mtd: MTD device structure
* @addr: virtual address in RAM of source/destination
* @len: number of data bytes to be transferred
@@ -463,7 +463,7 @@
}
/*
- * omap_nand_irq - GMPC irq handler
+ * omap_nand_irq - GPMC irq handler
* @this_irq: gpmc irq number
* @dev: omap_nand_info structure pointer is passed here
*/
@@ -1205,8 +1205,8 @@
/*
* If RDY/BSY line is connected to OMAP then use the omap ready
- * funcrtion and the generic nand_wait function which reads the status
- * register after monitoring the RDY/BSY line.Otherwise use a standard
+ * function and the generic nand_wait function which reads the status
+ * register after monitoring the RDY/BSY line. Otherwise use a standard
* chip delay which is slightly more than tR (AC Timing) of the NAND
* device and read status register until you get a failure or success
*/
@@ -1287,7 +1287,7 @@
info->nand.verify_buf = omap_verify_buf;
- /* selsect the ecc type */
+ /* select the ecc type */
if (pdata->ecc_opt == OMAP_ECC_HAMMING_CODE_DEFAULT)
info->nand.ecc.mode = NAND_ECC_SOFT;
else if ((pdata->ecc_opt == OMAP_ECC_HAMMING_CODE_HW) ||