ARM: at91: add atmel-mci support for chips and boards which can use it
Since atmel-mci driver supports all atmel mci versions,
use it instead of the deprecated at91_mci driver.
Platform data and all related configuration are removed.
Signed-off-by: Ludovic Desroches <ludovic.desroches@atmel.com>
[nicolas.ferre@atmel.com: remove at91_mci platform data]
Signed-off-by: Nicolas Ferre <nicolas.ferre@atmel.com>
diff --git a/arch/arm/mach-at91/board-foxg20.c b/arch/arm/mach-at91/board-foxg20.c
index 33411e6..0fc2181 100644
--- a/arch/arm/mach-at91/board-foxg20.c
+++ b/arch/arm/mach-at91/board-foxg20.c
@@ -85,7 +85,7 @@
* SPI devices.
*/
static struct spi_board_info foxg20_spi_devices[] = {
-#if !defined(CONFIG_MMC_AT91)
+#if !IS_ENABLED(CONFIG_MMC_ATMELMCI)
{
.modalias = "mtd_dataflash",
.chip_select = 1,
@@ -108,12 +108,12 @@
* MCI (SD/MMC)
* det_pin, wp_pin and vcc_pin are not connected
*/
-static struct at91_mmc_data __initdata foxg20_mmc_data = {
- .slot_b = 1,
- .wire4 = 1,
- .det_pin = -EINVAL,
- .wp_pin = -EINVAL,
- .vcc_pin = -EINVAL,
+static struct mci_platform_data __initdata foxg20_mci0_data = {
+ .slot[1] = {
+ .bus_width = 4,
+ .detect_pin = -EINVAL,
+ .wp_pin = -EINVAL,
+ },
};
@@ -246,7 +246,7 @@
/* Ethernet */
at91_add_device_eth(&foxg20_macb_data);
/* MMC */
- at91_add_device_mmc(0, &foxg20_mmc_data);
+ at91_add_device_mci(0, &foxg20_mci0_data);
/* I2C */
at91_add_device_i2c(foxg20_i2c_devices, ARRAY_SIZE(foxg20_i2c_devices));
/* LEDs */