ARM: at91: add atmel-mci support for chips and boards which can use it
Since atmel-mci driver supports all atmel mci versions,
use it instead of the deprecated at91_mci driver.
Platform data and all related configuration are removed.
Signed-off-by: Ludovic Desroches <ludovic.desroches@atmel.com>
[nicolas.ferre@atmel.com: remove at91_mci platform data]
Signed-off-by: Nicolas Ferre <nicolas.ferre@atmel.com>
diff --git a/arch/arm/mach-at91/board-sam9g20ek.c b/arch/arm/mach-at91/board-sam9g20ek.c
index 6860d34..40d595a 100644
--- a/arch/arm/mach-at91/board-sam9g20ek.c
+++ b/arch/arm/mach-at91/board-sam9g20ek.c
@@ -91,7 +91,7 @@
* SPI devices.
*/
static struct spi_board_info ek_spi_devices[] = {
-#if !(defined(CONFIG_MMC_ATMELMCI) || defined(CONFIG_MMC_AT91))
+#if !IS_ENABLED(CONFIG_MMC_ATMELMCI)
{ /* DataFlash chip */
.modalias = "mtd_dataflash",
.chip_select = 1,
@@ -198,7 +198,6 @@
* MCI (SD/MMC)
* wp_pin and vcc_pin are not connected
*/
-#if defined(CONFIG_MMC_ATMELMCI) || defined(CONFIG_MMC_ATMELMCI_MODULE)
static struct mci_platform_data __initdata ek_mmc_data = {
.slot[1] = {
.bus_width = 4,
@@ -207,28 +206,15 @@
},
};
-#else
-static struct at91_mmc_data __initdata ek_mmc_data = {
- .slot_b = 1, /* Only one slot so use slot B */
- .wire4 = 1,
- .det_pin = AT91_PIN_PC9,
- .wp_pin = -EINVAL,
- .vcc_pin = -EINVAL,
-};
-#endif
static void __init ek_add_device_mmc(void)
{
-#if defined(CONFIG_MMC_ATMELMCI) || defined(CONFIG_MMC_ATMELMCI_MODULE)
if (ek_have_2mmc()) {
ek_mmc_data.slot[0].bus_width = 4;
ek_mmc_data.slot[0].detect_pin = AT91_PIN_PC2;
ek_mmc_data.slot[0].wp_pin = -1;
}
at91_add_device_mci(0, &ek_mmc_data);
-#else
- at91_add_device_mmc(0, &ek_mmc_data);
-#endif
}
/*