[media] tuner/xc2028: Add I2C flush callback
When loading the firmware, complete each chunk by sending an I2C flush
command to the frontend. Some devices like the tm6000 seem to require
this to properly flush the I2C buffers.
The current code in tm6000 executes the flush command once after each
I2C transfer, which slows down the firmware loading especially when
loading large BASE type images.
Signed-off-by: Thierry Reding <thierry.reding@avionic-design.de>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
diff --git a/drivers/media/common/tuners/tuner-xc2028.h b/drivers/media/common/tuners/tuner-xc2028.h
index 9778c96..9ebfb2d 100644
--- a/drivers/media/common/tuners/tuner-xc2028.h
+++ b/drivers/media/common/tuners/tuner-xc2028.h
@@ -54,6 +54,7 @@
/* xc2028 commands for callback */
#define XC2028_TUNER_RESET 0
#define XC2028_RESET_CLK 1
+#define XC2028_I2C_FLUSH 2
#if defined(CONFIG_MEDIA_TUNER_XC2028) || (defined(CONFIG_MEDIA_TUNER_XC2028_MODULE) && defined(MODULE))
extern struct dvb_frontend *xc2028_attach(struct dvb_frontend *fe,