ath9k: Enable MIB and TIM interrupts for station mode.
Enable operating mode specific interrupts in ath9k_add_interface instead
of ath9k_start.
Signed-off-by: Vivek Natarajan <vnatarajan@atheros.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath9k/main.c b/drivers/net/wireless/ath9k/main.c
index d8e8266..91f7a7b 100644
--- a/drivers/net/wireless/ath9k/main.c
+++ b/drivers/net/wireless/ath9k/main.c
@@ -1957,25 +1957,6 @@
if (sc->sc_ah->ah_caps.hw_caps & ATH9K_HW_CAP_HT)
sc->sc_imask |= ATH9K_INT_CST;
- /*
- * Enable MIB interrupts when there are hardware phy counters.
- * Note we only do this (at the moment) for station mode.
- */
- if (ath9k_hw_phycounters(sc->sc_ah) &&
- ((sc->sc_ah->ah_opmode == NL80211_IFTYPE_STATION) ||
- (sc->sc_ah->ah_opmode == NL80211_IFTYPE_ADHOC)))
- sc->sc_imask |= ATH9K_INT_MIB;
- /*
- * Some hardware processes the TIM IE and fires an
- * interrupt when the TIM bit is set. For hardware
- * that does, if not overridden by configuration,
- * enable the TIM interrupt when operating as station.
- */
- if ((sc->sc_ah->ah_caps.hw_caps & ATH9K_HW_CAP_ENHANCEDPM) &&
- (sc->sc_ah->ah_opmode == NL80211_IFTYPE_STATION) &&
- !sc->sc_config.swBeaconProcess)
- sc->sc_imask |= ATH9K_INT_TIM;
-
ath_cache_conf_rate(sc, &hw->conf);
sc->sc_flags &= ~SC_OP_INVALID;
@@ -2124,6 +2105,27 @@
/* Set the device opmode */
sc->sc_ah->ah_opmode = ic_opmode;
+ /*
+ * Enable MIB interrupts when there are hardware phy counters.
+ * Note we only do this (at the moment) for station mode.
+ */
+ if (ath9k_hw_phycounters(sc->sc_ah) &&
+ ((conf->type == NL80211_IFTYPE_STATION) ||
+ (conf->type == NL80211_IFTYPE_ADHOC)))
+ sc->sc_imask |= ATH9K_INT_MIB;
+ /*
+ * Some hardware processes the TIM IE and fires an
+ * interrupt when the TIM bit is set. For hardware
+ * that does, if not overridden by configuration,
+ * enable the TIM interrupt when operating as station.
+ */
+ if ((sc->sc_ah->ah_caps.hw_caps & ATH9K_HW_CAP_ENHANCEDPM) &&
+ (conf->type == NL80211_IFTYPE_STATION) &&
+ !sc->sc_config.swBeaconProcess)
+ sc->sc_imask |= ATH9K_INT_TIM;
+
+ ath9k_hw_set_interrupts(sc->sc_ah, sc->sc_imask);
+
if (conf->type == NL80211_IFTYPE_AP) {
/* TODO: is this a suitable place to start ANI for AP mode? */
/* Start ANI */