ne2k: convert to net_device_ops
Convert driver to new net_device_ops. Compile tested only.
This required some additional work to export common code ei_XXX.
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ne2k-pci.c b/drivers/net/ne2k-pci.c
index ea22ae2..62f20ba 100644
--- a/drivers/net/ne2k-pci.c
+++ b/drivers/net/ne2k-pci.c
@@ -200,6 +200,19 @@
in the 'dev' and 'ei_status' structures.
*/
+static const struct net_device_ops ne2k_netdev_ops = {
+ .ndo_open = ne2k_pci_open,
+ .ndo_stop = ne2k_pci_close,
+ .ndo_start_xmit = ei_start_xmit,
+ .ndo_tx_timeout = ei_tx_timeout,
+ .ndo_get_stats = ei_get_stats,
+ .ndo_set_multicast_list = ei_set_multicast_list,
+ .ndo_validate_addr = eth_validate_addr,
+ .ndo_change_mtu = eth_change_mtu,
+#ifdef CONFIG_NET_POLL_CONTROLLER
+ .ndo_poll_controller = ei_poll,
+#endif
+};
static int __devinit ne2k_pci_init_one (struct pci_dev *pdev,
const struct pci_device_id *ent)
@@ -265,6 +278,8 @@
dev_err(&pdev->dev, "cannot allocate ethernet device\n");
goto err_out_free_res;
}
+ dev->netdev_ops = &ne2k_netdev_ops;
+
SET_NETDEV_DEV(dev, &pdev->dev);
/* Reset card. Who knows what dain-bramaged state it was left in. */
@@ -353,12 +368,8 @@
ei_status.block_output = &ne2k_pci_block_output;
ei_status.get_8390_hdr = &ne2k_pci_get_8390_hdr;
ei_status.priv = (unsigned long) pdev;
- dev->open = &ne2k_pci_open;
- dev->stop = &ne2k_pci_close;
+
dev->ethtool_ops = &ne2k_pci_ethtool_ops;
-#ifdef CONFIG_NET_POLL_CONTROLLER
- dev->poll_controller = ei_poll;
-#endif
NS8390_init(dev, 0);
i = register_netdev(dev);