ARM: dts: mvebu: a385-db-ap: add default partition description for NAND
The Armada 385 Access Point Development board contains NAND FLSH which is
already enabled in existing dts. Nevertheless the default partition
description was missing.
Signed-off-by: Grzegorz Jaszczyk <jaz@semihalf.com>
Acked-by: Gregory CLEMENT <gregory.clement@free-electrons.com>
Signed-off-by: Gregory CLEMENT <gregory.clement@free-electrons.com>
diff --git a/arch/arm/boot/dts/armada-385-db-ap.dts b/arch/arm/boot/dts/armada-385-db-ap.dts
index 4f7c3aa..db5b9f6 100644
--- a/arch/arm/boot/dts/armada-385-db-ap.dts
+++ b/arch/arm/boot/dts/armada-385-db-ap.dts
@@ -168,15 +168,35 @@
nfc: flash@d0000 {
status = "okay";
- #address-cells = <1>;
- #size-cells = <1>;
-
num-cs = <1>;
nand-ecc-strength = <4>;
nand-ecc-step-size = <512>;
marvell,nand-keep-config;
marvell,nand-enable-arbiter;
nand-on-flash-bbt;
+
+ partitions {
+ compatible = "fixed-partitions";
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ partition@0 {
+ label = "U-Boot";
+ reg = <0x00000000 0x00800000>;
+ read-only;
+ };
+
+ partition@800000 {
+ label = "uImage";
+ reg = <0x00800000 0x00400000>;
+ read-only;
+ };
+
+ partition@c00000 {
+ label = "Root";
+ reg = <0x00c00000 0x3f400000>;
+ };
+ };
};
usb3@f0000 {