ide: remove stale ide.h "configuration options"
Remove stale ide.h "configuration options":
* INITIAL_MULT_COUNT - always defined to 0
* SUPPORT_SLOW_DATA_PORTS - unused
* OK_TO_RESET_CONTROLLER - always defined to 1
* DISABLE_IRQ_NOSYNC - always defined to 0
Leave SUPPORT_VLB_SYNC (defined to 0 for CRIS and FRV, otherwise to 1)
for now but disallow overriding it by <asm/ide.h>.
There should be no functionality changes caused by this patch.
Acked-by: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
diff --git a/drivers/ide/ide-probe.c b/drivers/ide/ide-probe.c
index 0dda7ac..8e5d8dd 100644
--- a/drivers/ide/ide-probe.c
+++ b/drivers/ide/ide-probe.c
@@ -95,10 +95,10 @@
#ifdef CONFIG_IDEDISK_MULTI_MODE
id->multsect = ((id->max_multsect/2) > 1) ? id->max_multsect : 0;
id->multsect_valid = id->multsect ? 1 : 0;
- drive->mult_req = id->multsect_valid ? id->max_multsect : INITIAL_MULT_COUNT;
+ drive->mult_req = id->multsect_valid ? id->max_multsect : 0;
drive->special.b.set_multmode = drive->mult_req ? 1 : 0;
#else /* original, pre IDE-NFG, per request of AC */
- drive->mult_req = INITIAL_MULT_COUNT;
+ drive->mult_req = 0;
if (drive->mult_req > id->max_multsect)
drive->mult_req = id->max_multsect;
if (drive->mult_req || ((id->multsect_valid & 1) && id->multsect))