staging/rdma/hfi1: Disable thermal polling before sensor initialization
During driver load the thermal sensor needs to be reset prior
to initialization of the sensor. This prevents a possible sensor lock
up which can cause the wrong temperature value to be reported.
This fix leads to remove disabling thermal polling from
reset_asic_csrs() function.
Reviewed by: Dennis Dalessandro <dennis.dalessandro@intel.com>
Reviewed by: Easwar Hariharan <easwar.hariharan@intel.com>
Signed-off-by: Jareer Abdel-Qader <jareer.h.abdel-qader@intel.com>
Signed-off-by: Ira Weiny <ira.weiny@intel.com>
Signed-off-by: Jubin John <jubin.john@intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/staging/rdma/hfi1/chip.c b/drivers/staging/rdma/hfi1/chip.c
index dd2ba25..e842aee 100644
--- a/drivers/staging/rdma/hfi1/chip.c
+++ b/drivers/staging/rdma/hfi1/chip.c
@@ -9449,7 +9449,7 @@
/* We might want to retain this state across FLR if we ever use it */
write_csr(dd, ASIC_CFG_DRV_STR, 0);
- write_csr(dd, ASIC_CFG_THERM_POLL_EN, 0);
+ /* ASIC_CFG_THERM_POLL_EN leave alone */
/* ASIC_STS_THERM read-only */
/* ASIC_CFG_RESET leave alone */
@@ -10794,7 +10794,9 @@
acquire_hw_mutex(dd);
dd_dev_info(dd, "Initializing thermal sensor\n");
-
+ /* Disable polling of thermal readings */
+ write_csr(dd, ASIC_CFG_THERM_POLL_EN, 0x0);
+ msleep(100);
/* Thermal Sensor Initialization */
/* Step 1: Reset the Thermal SBus Receiver */
ret = sbus_request_slow(dd, SBUS_THERMAL, 0x0,