ARM: dts: Add HS400 support for exynos5420 and exynos5800
HS400 timing values are added for SMDK5420, exynos5420-peach-pit
and exynos5800-peach-pi boards. This also adds RCLK GPIO line,
this gpio should be in pull-down state.
This also enables HS400 on peach-pi and this updates the clock
frequency to 800MHz to be set as input clock to controller.
Signed-off-by: Seungwon Jeon <tgih.jun@samsung.com>
[alim.akhtar@samsung.com: addressed review comments]
Signed-off-by: Alim Akhtar <alim.akhtar@samsung.com>
Acked-by: Jaehoon Chung <jh80.chung@samsung.com>
Signed-off-by: Kukjin Kim <kgene@kernel.org>
diff --git a/arch/arm/boot/dts/exynos5800-peach-pi.dts b/arch/arm/boot/dts/exynos5800-peach-pi.dts
index c833bac..412f41d 100644
--- a/arch/arm/boot/dts/exynos5800-peach-pi.dts
+++ b/arch/arm/boot/dts/exynos5800-peach-pi.dts
@@ -654,15 +654,18 @@
num-slots = <1>;
broken-cd;
mmc-hs200-1_8v;
+ mmc-hs400-1_8v;
cap-mmc-highspeed;
non-removable;
card-detect-delay = <200>;
- clock-frequency = <400000000>;
+ clock-frequency = <800000000>;
samsung,dw-mshc-ciu-div = <3>;
samsung,dw-mshc-sdr-timing = <0 4>;
samsung,dw-mshc-ddr-timing = <0 2>;
+ samsung,dw-mshc-hs400-timing = <0 2>;
+ samsung,read-strobe-delay = <90>;
pinctrl-names = "default";
- pinctrl-0 = <&sd0_clk &sd0_cmd &sd0_bus1 &sd0_bus4 &sd0_bus8>;
+ pinctrl-0 = <&sd0_clk &sd0_cmd &sd0_bus1 &sd0_bus4 &sd0_bus8 &sd0_rclk>;
bus-width = <8>;
};