ASoC: fsl_esai: Set PCRC and PRRC registers at the end of hw_params()
According to Reference Manual -- ESAI Initialization chapter, as the
standard procedure of ESAI personal reset, the PCRC and PRRC registers
should be remained in its reset value and then configured after T/RCCR
and T/RCR configurations's done but before TE/RE's enabling.
So this patch moves PCRC and PRRC settings to the end of hw_params().
Signed-off-by: Nicolin Chen <Guangyu.Chen@freescale.com>
Signed-off-by: Mark Brown <broonie@linaro.org>
diff --git a/sound/soc/fsl/fsl_esai.c b/sound/soc/fsl/fsl_esai.c
index c674fd9..496ce2e 100644
--- a/sound/soc/fsl/fsl_esai.c
+++ b/sound/soc/fsl/fsl_esai.c
@@ -461,12 +461,6 @@
}
if (!dai->active) {
- /* Reset Port C */
- regmap_update_bits(esai_priv->regmap, REG_ESAI_PRRC,
- ESAI_PRRC_PDC_MASK, ESAI_PRRC_PDC(ESAI_GPIO));
- regmap_update_bits(esai_priv->regmap, REG_ESAI_PCRC,
- ESAI_PCRC_PC_MASK, ESAI_PCRC_PC(ESAI_GPIO));
-
/* Set synchronous mode */
regmap_update_bits(esai_priv->regmap, REG_ESAI_SAICR,
ESAI_SAICR_SYNC, esai_priv->synchronous ?
@@ -526,6 +520,11 @@
regmap_update_bits(esai_priv->regmap, REG_ESAI_xCR(tx), mask, val);
+ /* Remove ESAI personal reset by configuring ESAI_PCRC and ESAI_PRRC */
+ regmap_update_bits(esai_priv->regmap, REG_ESAI_PRRC,
+ ESAI_PRRC_PDC_MASK, ESAI_PRRC_PDC(ESAI_GPIO));
+ regmap_update_bits(esai_priv->regmap, REG_ESAI_PCRC,
+ ESAI_PCRC_PC_MASK, ESAI_PCRC_PC(ESAI_GPIO));
return 0;
}