powerpc: Merge 32 and 64-bit dma code
We essentially adopt the 64-bit dma code, with some changes to support
32-bit systems, including HIGHMEM. dma functions on 32-bit are now
invoked via accessor functions which call the correct op for a device based
on archdata dma_ops. If there is no archdata dma_ops, this defaults
to dma_direct_ops.
In addition, the dma_map/unmap_page functions are added to dma_ops
because we can't just fall back on map/unmap_single when HIGHMEM is
enabled. In the case of dma_direct_*, we stop using map/unmap_single
and just use the page version - this saves a lot of ugly
ifdeffing. We leave map/unmap_single in the dma_ops definition,
though, because they are needed by the iommu code, which does not
implement map/unmap_page. Ideally, going forward, we will completely
eliminate map/unmap_single and just have map/unmap_page, if it's
workable for 64-bit.
Signed-off-by: Becky Bruce <becky.bruce@freescale.com>
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
diff --git a/arch/powerpc/include/asm/machdep.h b/arch/powerpc/include/asm/machdep.h
index 893aafd..2740c44 100644
--- a/arch/powerpc/include/asm/machdep.h
+++ b/arch/powerpc/include/asm/machdep.h
@@ -88,8 +88,6 @@
unsigned long (*tce_get)(struct iommu_table *tbl,
long index);
void (*tce_flush)(struct iommu_table *tbl);
- void (*pci_dma_dev_setup)(struct pci_dev *dev);
- void (*pci_dma_bus_setup)(struct pci_bus *bus);
void __iomem * (*ioremap)(phys_addr_t addr, unsigned long size,
unsigned long flags);
@@ -101,6 +99,9 @@
#endif
#endif /* CONFIG_PPC64 */
+ void (*pci_dma_dev_setup)(struct pci_dev *dev);
+ void (*pci_dma_bus_setup)(struct pci_bus *bus);
+
int (*probe)(void);
void (*setup_arch)(void); /* Optional, may be NULL */
void (*init_early)(void);